810623

BeF Home Passive - HOT AIR FIREPLACE INSERTS Manual

3
Zoom out
Zoom in
Previous page
1/9
Next page
________________________________________________________________________________________________________________________________
Firma: BeF Home, s.r.o. Strana 3 (celkem 9) Platí od: 1. 4. 2014
Vydání: 4
Adequate chimney:
A fireplace insert must be connected into a chimney in accordance with national technical standards and regulations. Connection must be done
only with with the approval of chimney sweep. The chimney must be directly connected, dry and lined with fire-bricks. If the fireplace insert
should be connected to a chimney already built, it is necessary to clean the chimney and a chimney sweep must check its tightness and
condition. A chimney sweep also checks if the chimney is suitable for fireplace insert connection. In case when the chimney does not exist or
it is not suitable the new chimney dimensions must be according to the Equipment certificate. Low effective height limit of a stack flue is 5 m
if counted from the discharge of combustion products slot. In single cases it is possible to connect even to a stack flue with less effective
height than 5 m. It must be documented by a calculation of combustion products way that this height is enough for the connection. The
fireplace insert must have its own chimney.
Chimney parameters:
Chimney parameters in line with EN 13384-1 are found in the Equipment Certificate.
Pict.1
Ceiling (floor) prostection:
Ceilings without a sufficient lateral distribution (e.g. wooden ceilings) must be
protected by a 6 cm thick concrete layer and 6 cm thick thermal insulation layer,
where the fireplace insert is situated. Consulting a structural engineer is
recommended. If the floor, where the fireplace insert will be situated, has an adequate
lateral distribution a 6 cm thick thermal insulation layer is enough.
The floors in front of the fireplace insert:
A floor made of combustible material in front of the fireplace insert must be protected
by an adequate non-combustible material layer. Dimensions of this non-combustible
area must be at least: 800mm in the sideways direction of the opening side
(min.dimension H on pict.1) and 400mm to the front in the direction of the opening
side (min.dimension S on pict.1)
1 - smoke flue
2 - fireplace insert
3 - bottom of the hearth
4 - surround
5 - floor
Schema of fireplace insert installation:
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BeF Home Passive - HOT AIR FIREPLACE INSERTS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BeF Home Passive - HOT AIR FIREPLACE INSERTS in the language / languages: English as an attachment in your email.

The manual is 0.71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info