745719
28
Zoom out
Zoom in
Previous page
1/40
Next page
28
Fig. 3
5
4
6
3
1
2
Connecting several heating sources to the same chimney
It is possible to connect several units to some chimneys. All applicable regulations must rst be consul-
ted, in your building code and with your local chimney sweep.
Chimney re
In the event of a chimney re:
Close all dampers in the stove and chimney and immediately call the re department.
Before using the wood-burning stove again, your local chimney sweep must rst inspect the chimney.
Cleaning and Maintaining your Wood-Burning Stove
Warning:
Cleaning and maintenance of your wood-burning stove may only be performed when it is cool.
External Cleaning
The easiest is to vacuum clean the stove on the outside using a small nozzle with soft brush-es. You can
also wipe the stove clean using a dry, soft cloth or a soft duster. But remember only to do it when the stove
is cold! Do not use water, spirit or any other kind of cleaner, as this will damage the lacquer.
Cleaning the Glass Door
Your WIKING wood-burning stove is equipped with a pane-ush system, which reduces the build-up of
soot on the glass. If soot somehow accumulates on the pane, it can be cleaned by wiping the glass with
a moist paper towel dipped in ash. Afterwards, dry with a clean paper towel. You should also ensure that
air gaps in the door frame are free of ash and soot particles. Also ensure that the seals on the stove are
soft and fully intact; if they are not, ”false” air can enter the stove, which makes it more difcult to control
combustion and can in turn cause overheating or soot accumulation. Faulty or worn seals should there-
fore be replaced and can be purchased at your local wood-burning stove dealer.
Emptying the Ash Pan
Important: Be aware that embers in the ash can remain hot for up to 24 hours after the re in the stove
has gone out!
The ash pan is most easily emptied by pulling a waste bag over the pan, turning the pan upside down, and
then carefully pulling it up and out of the bag again.
Cleaning the combustion chamber
In order to extend the service lifetime of the wood-burning stove, it should be thoroughly serviced once a
year. First remove ash and soot from the combustion chamber. Carefully remove the vermiculite plates,
one after the other.
In Figure 3 you can see which plates are found
inside the combustion chamber:
1. Base plate 4. Left side plate
2. Front plate 5. Smoke deector (top plate)
3. Right side plate 6. Rear plate
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wiking Scandic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wiking Scandic in the language / languages: English, German as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wiking Scandic

Wiking Scandic Usermanual and installation guide - Dutch, French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info