745719
30
Zoom out
Zoom in
Previous page
1/40
Next page
30
Trouble Shooting
If you experience that your wood-burning stove is not functioning optimally, consult this table to nd some
usual problems that may arise and how to solve them. If you cannot solve them and/or other problems
occur, pleas contact your maintenance man or wood-burning stove dealer.
Problem Possible cause Try the following
I cannot make a
sufcient re in the
stove.
Incorrect lighting Further information: See the section on lighting and
ring the stove on page 26.
Poor chimney draft Ensure that the smoke pipe or chimney is not
blocked. Ensure that the chimney height is correct in
relation to its surroundings.
The glass pane is
covered in soot.
The wood is too moist. Only re with rewood that has dried for at least 12
months beneath a covered shed and with a maxi-
mum water content of 20%..
A seal in the door is loose. The seals should be soft and exible. If they are not,
replace them. New seals can be purchased from
your local wood-burning stove dealer.
Insufcient supply of se-
condary air to the pane-
ushing system.
Push the secondary damper all the way to the right.
Open the primary damper just a bit, if necessary, or
see below.
The temperature inside
the stove is too low.
Add more rewood to the wood-burning stove and
push both dampers all the way to the right.
Smoke enters the
room when I open
the door.
The damper in the
chimney is closed.
Open the damper.
Poor chimney draft. Ensure that the smoke pipe or chimney is not
blocked. Ensure that the chimney height is correct in
relation to its surroundings.
The rewood is in ames. Never open the door if the rewood is in ames.
The re-proof ma-
terials in the com-
bustion chamber
are blackened af-
ter ring.
You have not red
enough, i.e., there is not
enough air or rewood.
Push the lever under the door all the way to the right
to open up primary air. Moreover, igniting a larger
quantity of wood might be needed.
Combustion is
uncontrollable.
A seal in the door or ash
drawer is loose.
The seals should be soft and exible. If they are not,
replace them. New seals can be purchased from
your local wood-burning stove dealer.
Excess chimney draft Close the damper in the chimney a bit at a time until
the problem is solved. At the same time, completely
shut off the primary air supply.
The door is not complet-
ely sealed.
Close the door completely. If it cannot close complet-
ely, it must be replaced with an original spare part.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wiking Scandic at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wiking Scandic in the language / languages: English, German as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wiking Scandic

Wiking Scandic Usermanual and installation guide - Dutch, French - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info