730156

Xiaomi MiJia Honeywell Gas Leak Detector Manual

4
Zoom out
Zoom in
Previous page
1/6
Next page
Main parameters
operation.
3. Alarm
If the device has no faults, but as a result of exceeding the permissible level of gas
concentration in the room, the audible alarm turns on, the red indicator lights up,
and the signal sounds. To turn o the signal, press the «Sound / Self-Diagnosis»
button, and after about 70 seconds the device will resume its operation.
If the gas concentration level is below the maximum permissible value of the
sensor, it automatically switches to normal operation. If other devices are
connected to the sensor, it is necessary to conrm the elimination of a hazardous
situation and restore the gas supply. Reconnect the devices according to the
recommendations in the operating instructions.
4. Fault status
In case of a malfunction, the yellow indicator lights up and a beep sounds, and
two beeps sound every 5 seconds. You can press the «Sound / Self-Diagnosis»
button, after 12 hours the audible alarm will turn on again.
5. Duplicate a signal on another device
If the sensor is operating in normal mode, press and hold the «Sound / Self-
Diagnosis» button for 3 seconds to enter the signal duplication mode. In this case,
the red indicator will light up, a continuous loud beep will turn on. If you press and
hold the «Sound / Self-Diagnosis» button for 11 seconds, an alarm is output to
the connected device. If you release the button, you immediately exit the signal
duplication mode.
Maintenance
To ensure normal operation of the sensor, perform maintenance on the device
following the following recommendations:
1. Install, use and maintain the sensor, following the recommendations in the
manual;
2. It is recommended to perform a self-diagnosis of the device once a month:
press the «Sound / Self-diagnosis» button, make sure that the sensor is
functioning normally;
3. It is recommended to wipe the external surface of the device every season,
clean the air intake openings from dust and grease, make sure that the sensor
holes have good entrance patency, and the alarm system works properly. To clean
the device use a dry towel, do not use alcohol, chemical, other abrasives or too
wet a towel.
4. It is recommended to calibrate once a year.
Calibration should be performed by qualied organizations. Do not perform a
calibration yourself.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xiaomi MiJia Honeywell Gas Leak Detector at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xiaomi MiJia Honeywell Gas Leak Detector in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info