633391
4
Zoom out
Zoom in
Previous page
1/8
Next page
CLEANINGANDMAINTENANCE
Besidesoccasionalcleaningandbatteryreplacement,thevoltagetesterismaintenance-free.
Thevoltagetestermustbedisconnectedfromalldevicesundertestbeforecleaning.
Aftercleaning,allowtheproducttodrycompletelybeforeusingitagain.
Nevertrytoopenthehousing,apartfromthebatterycompartment.
Checkthetechnicalsafetyofthevoltagetesterregularly.Itisunderstoodthatsafeoperationisnolongerpossible:
• ifthedeviceorheconnectingcableisvisiblydamaged
• afterprolongedstorageunderunfavourableconditions
• afterextraordinarytransportstress
Theoutsideofthedeviceshouldbecleanedwithasoft,dampclothorbrushonly.Donotuseabrasiveorchemicalcleaning
agentswhichcoulddamagethehousingorimpairoperation.
DISPOSAL
Electronicproductsarerecyclablesanddonotbelonginthehouseholdwaste.Whenthedevicehasreached
theendofitsservicelife,pleasedisposeofit,accordingtothecurrentstatutoryrequirements,atyourlocal
collectingsite.Itisprohibitedtodisposeofthedevicewithdomesticwaste.
Disposalofusedbatteries!
Youastheultimateconsumerarelegallyobliged(RegulationonSpentBatteries)toreturnalldeadbatteries;disposalinthe
householdwasteisprohibited!
Batteriescontaininghazardoussubstancearemarkedbythesymbolsalongsidewhichindicatestheprohibition
ofdisposalwithdomesticwaste.Thesymbolsoftherelevantheavymetalsare:Cd=Cadmium,Hg=Mercury,
Pb=Lead.Youcanhandinyourusedbatteriesatthecollectionpointsofyourcommunityatnocostorevery-
wherewherebatteries/accumulatorsaresold.
Thusyoufullyourstatutoryobligationsandcontributetotheprotectionoftheenvironment!
TECHNICALDATA
Generalinformation
VoltageindicatorLED 12,24,36,50,120,230,400,690VAC/DC
VoltageindicatorLCD 12-690VAC/DC
ResolutionLCD 0.1V(12-300V),1V(>300V)
Polarityindicator +,-,+/-(AC)
IndicatortoleranceLCD ±(3%+5counts)
IndicatortoleranceLED accordingtoEN61243-3
Voltagedisplay automatic
Signal >38V,continuity
Displaydelay <1sLED
Frequencyrangef DC,16...400Hz
Powerinput approx.2.1Wat690V
MaxtestcurrentI <3.5mA
WarningindicatorLED >50V/AC,>120V/DC
Measuringtime/cycle max.30seconds
Resttime 240seconds
LED/LCDindicatorfrom >10VAC/DC
Powersupply 2x1.5V(AAA/LR03)
Batterypowersupply approx.80mA
Temperaturerangeoperation -15to+55°C
Storagetemperature -20to+70°C
Rel.Humidity max.85%,non-condensing
Measurementcategory CATIII1000V,CATIV600V
Pollutiondegree 2
Operatingaltitude max.2000maboveN.N.
Protectiontype IP64
Rotatingelddirectionindicator onlyongroundedthree-phasesystems!
Voltagerange 120-400V/AC
Frequencyrange 50/60Hz
Continuitytest
Testrange 0-500kΩ(+50%)
Overvoltageprotection 690VDC/AC
Single-polephasetest
Voltagerange 100-690V/AC
Frequencyrange 50/60Hz

Legalnotice
TheseoperatinginstructionsareapublicationbyConradElectronicSE,Klaus-Conrad-Str.1,D-92240Hirschau(www.conrad.com).
Allrightsincludingtranslationreserved.Reproductionbyanymethod,e.g.photocopy,microlming,orthecaptureinelectronicdata
processingsystemsrequirethepriorwrittenapprovalbytheeditor.Reprinting,alsoinpart,isprohibited.
Theseoperatinginstructionsrepresentthetechnicalstatusatthetimeofprinting.
©Copyright2014byConradElectronicSE.
G
• Closeandlockthebatterycompartmentinreverseorder.Makesurethatthesealingringonthebatterycompartment
doesnotgetpinchedordamaged.Thereisonlyonepositionforthebatterycompartmentcovertomatchthedevice.The
groovemustbelocatedontheright.
Batteryreplacementisnecessarywhenthelevelindicator(8)isnolongerilluminatedduringthefunctiontest,orthebattery
replacementsymbolappearsontheLCD,orifyoucannothearthesignalsoundanylonger,whenthecontactsofthetwo
probes(4and6)areincontact.
Whenthebatteriesareempty,onlythewarningindicator(10)for“DangerousVoltage”willfunction
whenthetestvoltagereaches50V/ACor120V/DC.Donotevertouchthemeasuringcontacts,ifthis
indicatorison.
Operationwhilethebatterycompartmentisopen,isnotpermitted.
Topreventdamagetothedevicefromleakingbatteries,removethebatteriesfromthedeviceifyouwillnotbeusingitfora
longerperiod.Forthesamereason,werecommendthatyouremoveatbatteriesimmediately.
Compatiblealkalinebatteriescanbeobtainedwiththefollowingordernumber:
Ord.no.652303(2pcs.Pleaseorder1xunit).
Onlyusealkalinebatteries;theyarehigh-performanceanddurable.
MESUREMENTPOINTSILLUMINATION
TheVC-55hasabattery-operatedmeasuringpointillumination.
Pressbutton(15)toturnilluminationonandoff.Thelightisonforabout130secondsanddisappearsautomatically.
PERFORMINGTESTSANDMEASUREMENTS
Thetwo-polevoltagetesterconsistsofthetwoprobes(4and6),aconnectingcable(18)andtheindicatorpanel.
Alwaysholdthevoltagetesterinaway,thatyoucanlookdownontotheindicatorpanel.Illuminatedindicatorsmaybe
adverselyaffectedbystronglight.
ForDCmeasurements,theprobetipL2+(6)isthepositivepole,andtheprobetipL1-(4)isthenegativepole.
TheVC-55willautonomouslyturnonwhentheteststarts(entrylevel>10V),andwhenthetesthasbeencompleted,itturns
off.
Alwayscheckthatthevoltagetesterisfunctioningproperlypriorandafteremployment.Measure
aknownvoltagesource(mainsvoltage230V/AC,forexample)rst,andchecktheaccuracyofthe
readouts.Intheeventofoneormoreindicatingranges(8)fail,donotusethevoltagetester.
Ifthemeterdoesnotdisplayanyfunctionorindividualindicatorrangesarenotfunctioning,decommis-
sionthevoltagetester.Adefectivevoltagetestermustnotbeused.
Observetheregulationsregardingworkwithelectricalsystems.Personalprotectiveequipmentmustbe
usedwhenworkingonsystemswithdangerouselectricalvoltage.
Themaximumpermitteddutycycle(ON)is30seconds.Afterthattimehaspassed,anoperationalrest
of240minutesatleast,hastobemaintained.
Thefollowingmeasurementfunctionscanbeconducted:
a)Two-polevoltagemetering
Alwaysholdthevoltagetesterbythehandlesdesignedforthispurpose(1and16).Neverreachbeyondthetactilebarrierof
thegrip(5and13).
Guidethetwoprobetipsontothemeasurementpointstobetested.Thevoltagerangeisshownonthelevelindicator(8)and
thepresentmeasuringvoltageisshownontheLCDdisplay.
Thelightindicators(+)and(-)showthetypeofvoltageandthecorrespondingpolarity.Ifbothindicators,LED(+)and(-)are
litatthesametime,alternatingcurrent(AC)ispresent.PolarityisonlyindicatedbymeansofthetwoLEDs.
Atavoltageofabout38V/ACor100V/DCasignalsoundisproduced.Therotatingeldindicator“L”and“R”mayash
duringmetering.Thisisatechnicalissueandiswithoutsignicanceorimpactonthemeasuringprocess.
ThetwoprobetipsL1undL2canbeconnectedtooneanother,laterallyviathefasteningclamponthe
handlegripbarrierofprobetipL1(5).
Thedistancebetweenthetwoprobesis19mm,whichcomplieswiththestandardizedcontactgapfor
EUandsafetysocketoutlets.
Inaddition,establishingcontactinsidetheoutletsismadeeveneasierwhentheincluded4mm
adapterscrewsareused.Thatway,thevoltagetestercanbeguidedbyusingonehandonly.
Makesurethatyourhandremainswithinthegriparea(16)ofprobetipL2andthat
youdon’tcoverthedisplay.
b)Rotatingeldindicator
VC-55showstherotatingelddirectionofproperlygroundedthree-phasesystems(withbatteriesonly).Thevoltagetester
detectstheorderofincreasingphasestogroundpotential
Holdthevoltagetesterbythehandles(1)and(16)provided.Nevertouchthedevicebeyondthehandleends.
Connectthetwoprobestothemeasuringpointsthatyouwanttomeasure.
TheprobeL1(4)correspondstotheoutercable(phase)L1.
TheprobeL1(6)correspondstotheoutercable(phase)L2.
Theavailablevoltagerangeandthephasesequenceisrepresentedonthedisplay.
Theilluminatedindicators(12)showtheapplicablerotatingelddirection(L=leftturning/R=rightturning).
Example1: Example2:
ProbetipL1tooutercableL1, probetipL1tooutercableL2,
ProbetipL2tooutercableL2, probetipL2tooutercableL3,
Thecorrecteldrotation“R”isdisplayed Thecorrecteldrotation“R”isdisplayed
Example3:
ProbetipL1tooutercableL2,
ProbetipL2tooutercableL1,
Oppositephasesequence“L”isdisplayed
c)Continuitytest
Whenbatteriesareinserted,theVC-55canbeusedasacontinuitytester.
Holdthevoltagetesterbythehandles(1)and(16)provided.Nevertouchthedevicebeyondthehandleends.
Checkfunctionbeforeyourstartmetering.
Connectbothprobetipstooneanother.Asignalsoundsandthedisplayisilluminated(11).
Ifthisisnotthecase,replacethebatteriesasdescribedunder“Inserting/ReplacingtheBatteries”.
Thecontinuitytesterindicatesaresistanceofabout0-500kΩ(+50%)ascontinuity.
d)Single-polephasetest
Whenbatteriesareinserted,theVC-55canbeusedasasingle-polephasetester.
Holdthevoltagetesterbythehandles(1)and(16)provided.Nevertouchthedevicebeyondthehandleends.
Thissingle-polephasetestservesasaquicktestonly,andpriortoanyworkconductedonthislinethe
absenceofvoltagemustberecheckedusingthedouble-polemeasuringmethod.Observetheregula-
tionsregardingworkwithelectricalsystems.
ContactprobetipL2withthemeasuringpointtobetested.ProbeL1hasnocontact.
Ifanalternatingvoltage>100Vispresent,theindicator(10)lightsupandasignalsounds.
Thesingle-polephasedisplaymaybeadverselyaffectedbyunfavourableambientconditions(electro-
staticelds,goodinsulationetc.).However,performanadditionaldouble-polevoltagetesttodetermine
thatvoltageisabsent.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft VC-55 LCD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft VC-55 LCD in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info