576540
37
Zoom out
Zoom in
Previous page
1/41
Next page
37 GB
Safety / OperationIntroduction / Safety
DANGER OF ELECTRIC SHOCK!
- Do not operate the appliance if the cables,
the mains cable or mains plug are damaged.
A damaged mains cable indicates a life-threat-
ening danger due to electric shock.
Before connecting to the power, ensure that the
power connection is earthed, is 230 V∼ 50 Hz,
and is 16 A fused and equipped with an RCCB
switch (residual current circuit breaker) in accord-
ance with the current regulations!
- Disconnect the charger from the grid, before
you make or break connections to the battery.
- First, connect the clamp that is not connected
to the bodywork. Then connect the other clamp
to the bodywork, away from battery and fuel
pipe. Only after this, connect the charger to
the grid.
- After charging, disconnect the charger from
the grid. Only after this remove the clamp
from the bodywork. Following this, remove
the clamp from the battery.
DANGER OF EXPLOSION AND FIRE
HAZARD! Protect yourself from a highly ex-
plosive hydrogen-oxygen reaction!
- Ensure that during charge and charge retention
procedures, there are no naked lights (flames,
cinders or sparks)!
- Ensure that the plus cable does not come into
contact with fuel lines (e.g. petrol pipe)!
- Ensure that there is no possibility of ignition of
explosive or flammable substances, such as
petrol or solvents, while using charger!
DANGER OF CHEMICAL BURNS!
Wear protective glasses! Wear protective gloves!
If eyes or skin has come into contact with battery
acid, rinse the affected body region off with a
large amount of clean water and consult a doc-
tor straight away!
Avoid causing a short circuit when connecting
the charger to the battery. Connect the negative
pole connector cable only to the negative bat-
tery or to the body work. Connect the positive
pole connector cable only to the plus pole of
the battery!
Do not place the charger close to fire, heat or
to places with long-term exposure to tempera-
tures over 50 °C!
E
nsure that no fuel lines,electric cables, hydraulic
or water pipes are damaged by the screws dur-
ing assembly of the charger!
Do not cover the charger with any objects!
Protect the electrical contact surfaces of the
battery from short circuiting!
Only use the charger for charging and for
charge retention of 6 V / 12 V lead batteries.
Do not charge frozen batteries.
Operation
Before use
Before connecting the charger, the operating
instructions must be observed.
Furthermore, the instructions of the vehicle man-
ufacturer regarding a permanently connected
vehicle battery must be observed. Secure the
vehicle, switch off the ignition.
Clean the battery poles. Take care that while
doing so, your eyes do not come into contact
with the dirt.
Ensure sufficient ventilation.
Connecting
Connect the „+“pole clamp (red)
14
of the
charger to the „+“ pole of the battery.
Connect the „-“pole clamp (black)
15
to the
„-“ pole of the battery.
Connect the mains cable
13
of the charger to
the mains socket.
The battery voltage display
9
shows the cur-
rent battery voltage.
Should the connection of the clamps be swapped,
the LED „reverse connection“ lights up
5
.
Disconnect
Disconnect the appliance from the mains supply.
Remove the „-“ pole clamp (black)
15
from the
„-“ pole of the battery.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ultimate speed ULGD 3.8 A1 - IAN 92517 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ultimate speed ULGD 3.8 A1 - IAN 92517 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info