649685
6
Zoom out
Zoom in
Previous page
1/96
Next page
- 6 -
that reported on the data table. (C min).
Follow the instructions, taking great care to respect
the order given below.
- Remove the caps of the battery charger (if foreseen) so
as to let the gas produced go out.
- Check that the level of the electrolyte covers the plates
of the battery. If these were not covered add distilled
water and cover them up to 5-10 mm.
WARNING: USE THE MAXIMUM CAUTION
DURING THIS OPERATION AS THE
ELECTROLYTE IS A HIGHLY CORROSIVE
ACID.
- Make sure the battery charger is disconnected from the
power supply.
- Check the polarities of the battery terminals: positive for
the + symbol and negative for the - symbol.
NOTE: if the symbols are indistinguishable remember
that the positive terminal is the one not connected to the
vehicle chassis.
- Connect the red charge clamp to the positive terminal of
the battery ( + symbol).
- Connect the black charge clamp to the vehicle chassis,
at a safe distance from the battery and the fuel pipe.
NOTE: if the battery is not installed in the vehicle,
connect the clamp directly to the negative terminal of
the battery (- symbol).
CHARGING
- Power the battery charger by inserting the power cable
into the mains socket.
- During this phase the battery charger keeps the
charging current constant.
END OF CHARGING
- The battery charger FULL LED “
” lights up to
signal that charging has ended.
- Disconnect the power supply to the battery charger by
removing the power supply cable from the mains outlet.
- Disconnect the black charge clamp from the chassis of
the vehicle or from the negative terminal of the battery
(- symbol).
- Disconnect the red charge clamp from the positive
terminal of the battery (+ symbol).
- Store the battery charger in a dry place.
- Close up the battery cells with the appropriate plugs (if
present).
MAINTENANCE (enabled in TRONIC or PULSE
TRONIC mode only)
- Leave the battery charger connected to the mains.
- Do not interrupt the charge process.
- Leave the charge clamps connected to the battery even
after the charge process has been completed.
The battery charger will automatically interrupt and reboot
the charge phase maintaining the battery voltage within
the product default voltage range.
6


Need help? Post your question in this forum.

Forumrules
1

Forum

telwin-defender-8

Reset search

  • When it comes to charge the battery how can we say that the battery is charging is it blinking or not?? Submitted on 3-12-2021 at 06:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telwin Defender 8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telwin Defender 8 in the language / languages: All languages as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info