649685
5
Zoom out
Zoom in
Previous page
1/96
Next page
- 5 -
OPERATION ON THE BATTERY CHARGER.
2. INTRODUCTION AND GENERAL DESCRIPTION
- This battery charger can be used to charge free
electrolyte lead acid batteries used on petrol and diesel
engine vehicles, motor cycles, boats etc. and is suitable
for charging sealed batteries.
- Accumulators rechargeable in accordance to the output
voltage available: 6V / 3 cells, 12V / 6 cells.
- This model is a battery charger with a 100V-240V
50/60Hz single phase power supply, with electronically-
controlled constant current and voltage.
The charge current and voltage supplied by the
appliance follow the IU charge curve.
- Automatic detection of battery voltage (6V-12V).
- Standard equipment:
Cables with crocodile clips.
Cables tted with eyelets.
3. DESCRIPTION OF THE BATTERY CHARGER
Control, adjustment and signalling devices.
- The charging current is 0.75A:
- CHARGE LED “
”: charging in progress.
- FULL LED “
”: end of charging.
Attention: there is no polarity inversion
signal.
4. INSTALLATION
POSITIONING THE BATTERY CHARGER
- While the battery charger is in operation make sure it is
in a stable position.
- Do not lift the battery charger using the power supply
cable or the charge cable.
CONNECTIONTOPOWER
- The battery charger should be connected only and
exclusively to a power source with the neutral lead
connected to earth.
Check that the net voltage is the same as the voltage of
the equipment.
- Check that the power supply is protected by systems
as fuses or automatic switches, sufcient to support the
maximum absorption of welding.
- If you put an extension to the primary cable, the
diameter must be the same, never inferior.
- The connection to the power has to be made using the
cable.
5. OPERATION
BEFORE CHARGING
NB: Before charging check that the capacity of the
battery (Ah) which is to be charged, is not inferior to
5


Need help? Post your question in this forum.

Forumrules
1

Forum

telwin-defender-8

Reset search

  • When it comes to charge the battery how can we say that the battery is charging is it blinking or not?? Submitted on 3-12-2021 at 06:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telwin Defender 8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telwin Defender 8 in the language / languages: All languages as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info