655956
62
Zoom out
Zoom in
Previous page
1/160
Next page
Preparing for use
ENGLISH 22
Loosen and turn assembly flange (j)
x Put the wheel guard on a level surface with the
assembly flange (j) pointing up (screws (g) of the
assembly flange point up).
x Turn out screw (k).
Hold the nut below the assembly flange with flat
pliers.
x Twist the assembly flange against the wheel
guard so that the receptacle bore for the
screw (k) is located between the centre stop and
the right stop (m) on the wheel guard. The
assembly flange is hard to twist. Securely hold
the wheel guard when twisting.
Limit wheel guard rotating angle with screw (k)
x Turn in screw (k) again.
For this, guide the nut (n) below the assembly
flange with flat pliers and hold it when turning in
the screw.
Turning of the wheel guard is limited by the
stops on the wheel guard between which the nut
can be moved.
Install cutting device in the outer position
x Put the cutting device on the cutting device
carrier in the outer position. For this, guide both
screws (g) of the assembly flange through the
oblong holes and put the ribbed belt support (i)
into the ribbed belt.
x Check that the ribbed belt is running freely.
Correct placement of the ribbed belt if required.
x Put on the ribbed belt cover (14) again.
Adjust the ribbed belt tension
x Screw both attachment nuts (d) of the ribbed belt
cover onto the assembly flange screws. Only
tighten the nuts manually so that the ribbed belt
tension can still be set.
x Turn ribbed belt tension screw (13) towards the
right, e.g. clockwise, to increase the ribbed belt
tension). The correct tension is reached when
the square nut (e) is on the centre mark, i.e.
between "+" and "".
x Tighten both attachment nuts (d) firmly.
j
k
m
2
g
k
n
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 879-12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 879-12 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info