655956

Solo 879-12 Manual

64
Zoom out
Zoom in
Previous page
1/160
Next page
Starting up and switching off the engine
ENGLISH 24
Observe safety provisions!
Put the power tool level and free from obstacles on the flat floor Start-up position. Avoid any contact
between the cut-off wheel and body parts or objects.
Î Before every starting attempt press the
decompression valve (21)
x Put one foot on the rear handle (6) to support the
power tool against the floor.
x Securely hold the power tool at the top handle (4)
with one hand and push it firmly onto the ground.
x Operate the starter handle with the other hand (16).
Other start-up positions are not permissible!
Cold start:
x Pull the choke lever (19) (this also activates the part-throttle setting).
x Using the starter handle, start the engine until you hear it briefly ignite.
Note: the engine cannot start up and continue running while the choke lever is pulled out.
ÎAfter the first audible ignition, immediately:
x Press the choke lever back in again.
x Continue starting until the engine runs
x The engine is then running in part throttle.
x Briefly operate the throttle control to cancel the part control setting.
x The engine will then continue to run at idle speed.
Warm start:
x Start the engine in idle setting with the choke not pulled out
The following notes serve to increase the service life of the starter mechanism:
x Initially pull out the starter handle (16) slowly until resistance can be felt for start-up (upper dead point of
the piston).
x Then quickly and strongly pull through the starter handle.
x Always pull out the rope straight.
x Do not let the rope scrape across the rope eyelet edge .
x Danger of breaking rope!
Do not pull out the rope to the stop.
x Always return the starter handle to its initial position – do not let it snap back.
Damaged starter ropes can be replaced by specialist workshops authorised by us.
Release the throttle control and push the one-touch stop button.
Ensure that the cut-off wheel has stopped before putting down the power tool.
6 Starting up and switching off the engine
6.1 Starting process
6.2 Switching off the engine
… 64 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 879-12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 879-12 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info