655956

Solo 879-12 Manual

60
Zoom out
Zoom in
Previous page
1/160
Next page
Preparing for use
ENGLISH 20
Generally, the ribbed belt tension must be set
correctly when starting the power tool. At initial
starting, at re-starting after extended stand still,
after replacement of the ribbed belt or after any
other assembly work, always check the tension and
set the correct tension if required.
x Loosen both attachment nuts (a).
x Turn ribbed belt tensioning screw (13) towards
the right (clockwise).
Î Increase ribbed belt tension.
The square nut (b) moves to the mark "+".
x Turn ribbed belt tension screw (13) towards the
left (counter-clockwise):
Î Reduce ribbed belt tension.
The square nut (b) moves to the mark "".
x The correct tension is reached when the square
nut (b) is on the centre mark (c), in between "+"
and "".
x Tighten both attachment nuts (a) again.
Fine dust occurs when cutting mineral materials.
Recommendation: Use the water connection and
cut-off wheels suitable for wet cutting when cutting
mineral materials.
When cutting with the water supply connected, the
dust is suppressed, visibility is improved and the
cut-off wheel service life is increased by the cooling
effect of the water.
Before wet cutting:
x Connect suitable water line or suitable pressure
tank to the coupling connection (24).
x Operate the valve lever (28) to open or close the
water supply.
After wet cutting:
x Close the water supply, i.e. put the valve lever
across the connection piece.
x Let the cut-off wheel run at high speed for
another approx. 30 seconds to completely eject
the water.
Cleaning the screen filter insert in the coupling
piece (27): Î Chap. 8.2, page 30
5.6 Adjusting the ribbed belt tension
5.7 Water connection for wet cutting
water supply opened
(valve lever parallel)
water supply closed
(valve lever across)
b
a
13
c
c
b
… 60 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 879-12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 879-12 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info