16855

Sharp UX510 Manual

60
Zoom out
Zoom in
Previous page
1/114
Next page
<P=006>
How fax transmissions are detected:
Your fax detects fax transmissions in two ways when an answering machine is
connected, depending on whether the document is being sent automatically or
manually:
Automatic dialing: If the document is sent using a form of automatic dialing,
such as Rapid Key or Speed Dialing, the transmitting fax machine will send a
"calling tone" at 3-second intervals for a period of about 30 to 40 seconds after
dialing. When your fax detects this tone, it will disconnect the answering ma-
chine, send a "reception tone" in response, and begin receiving the transmission.
If the transmitting fax does not receive a reception tone from your fax within 30
to 40 seconds after dialing, it will usually hang up and automatically redial sev-
eral minutes later.
Since your fax may not be able to detect the transmitting fax’s calling tone until
after the outgoing message ends, it is important that the answering machine an-
swers the call within two rings and the outgoing message is less than 10 sec-
onds. Otherwise, your fax may not be able to establish communication with the
transmitting fax before the latter hangs up.
Manual dialing: If the document is being sent by normal (manual) dialing, the
transmitting fax machine does not send a calling tone. Instead, the person faxing
normally waits until they hear a reception tone and then presses their Start key.
In the case of an answering machine hook-up, they will hear your outgoing mes-
sage instead of a reception tone, and then press their Start key.
However, this does not signal a fax transmission to your fax. Instead, your fax
must use a function called "Quiet Detect Time" to detect the transmission. This
function causes your fax to disconnect the answering machine and begin recep-
tion if it detects a certain duration of silence.
Your fax is set to automatically begin fax reception if it detects a duration of si-
lence of four seconds. When the person faxing presses their Start key, the line
will go quiet, and the transmitting fax machine will wait for a reception tone
from your fax. Your fax will disconnect the answering machine four seconds af-
ter the key is pressed, and send a reception tone to tell the other fax machine to
begin transmission.
If your answering machine has a fast disconnect time and disconnects the line
before four seconds elapses, fax reception will not be possible. In this case, you
must shorten the Quiet Detect Time setting as described on the following page.
On the other hand, if the Quiet Detect Time setting is too short, your fax may in-
terrupt voice callers if they pause during their message or if there is a period of
silence in your outgoing message.
Chapter 7 Answering Machine Hookup
50
… 60 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sharp UX510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sharp UX510 in the language / languages: English as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info