Manual Seiko S351 (page 6 of 7) (English)

757537

Zoom out

Zoom in

1/7

After the starting time setting is completed, press button to start the stopwatch. For the stopwatch

operation, refer to the stopwatch operation explained above.

Notes:

・When the stopwatch is stopped, “STOP” and “ ″” marks are displayed.

・While the stopwatch is counting, “ ″” is not displayed.

・While the split time is measured, “SPLIT” and “ ″” are displayed. If button is pressed while the

split time is measured, the measurement is stopped and the total elapsed time is displayed in place

of the split time.

・A negative calculation result obtained in the time calculation mode can be set as the starting time

with the recall key. If button is pressed to start the stopwatch, however, the error mark “Error” is

displayed and the stopwatch will not start counting. Press the clear/clear entry key to reset the digits

to “0:00′00″” and then enter a proper starting time.

・The set staring time is not stored in memoty, and it will be canceled once the stopwatch is started.

・The arithmetic operation keys [＋] [−] and [＝] do not work in the stopwatch mode.

■NOTES ON THE BATTERIES 

When flashing “ ” mark appears in the upper left of the display,

replace the battery with a new one as soon as possible. Otherwise,

the watch may stop operating in 2 to 3 days. We suggest that you

have the battery replaced by a retailer from whom your watch was

purchased or a SEIKO dealer.

＊Even though the flashing “ ” mark is displayed, time accuracy is not

affected.

川

BATTERY LIFE INDICATOR

BATTERY LIFE

[Battery for the stopwatch]

A new normal battery will last approximately three years.

＊If the timer is used more than 10 times a day, the battery life may be less than

the specified period.



＊The battery in your watch may run down in less than the specified period

after the date ofpurchase, as it is a monitor battery inserted at the factory

to check the functions and performance of the watch.

＊The battery in your watch will therefore be replaced with a new one only at

cost even if it runs down within the guarantee period.

When replacing the battery, be sure to take your watch

to the retailer from whom your watch was purchased

or an AUTHORIZED SEIKO DEALER , and specify the

" SEIKO genuine SB battery ".

If an old battery is kept inside the watch for a long time,

electrolyte leakage may occur and a malfunction may be

caused. Be sure to replace the battery as soon as it runs

down to prevent any possible malfunction.

＊When a battery is taken out of a watch, it must be kept at a

place beyond the reach of an infant. In case it is swallowed

by an infant, consult a doctor immediately.

BATTERY CHANGE

■CARE OF YOUR STOPWATCH

Being equipped with the

number entry and other

keys as used in calculators,

your watch is not water

resistant according to the

water resistance standard

for watches. It can with-

stand, however, the

accidental contact with

splashes of water or rain. If

the watch is wet, wipe it

thoroughly dry with a soft

dry cloth or the like.

WATER RESISTANT ANTI-SHOCK

Light activities will not

affect yourwatch, but

be careful not to drop

your watch or hit it

against hard surfaces,

as this way cause

damage.

TEMPERATURE

Your watch is designed to work with stable accuracy

between normal temperature range of 5°C and 35°C .

Do not leave your watch in

direct sunlight or very high

temperatures for a long time.

• The display may become

black, but this condition will

be corrected when the

watch returns to normal

temperature .

Do not leave the watch in a very low

temperature, as this may cause :

1) A slight time loss or gain.

2) The change of digits to become

slow

(with accuracy remaining normal.)

The adove conditions will be corrected when the watch returns to normal

temperature.

If the watch is left in temperatures over 60 or below-10 for a long time,the

watch maystop operating, battery leakage may be occurred, or the battery

life may be shortened.

＊

℃ ℃

ANTI-MAGNETIC

Magnetism will not affect

the watch

As a small amount of moisture is included inside the

stopwatch , the inner surface of the glass may be

temporarily blurred if the atmospheric temperature is

long time, we suggest that you have the stopwatch checked

by the retailer from whom it was purchased.

lower than that inside the stopwatch . This does not

adversely affect it . However , if the blur persists for a

＊



■



TOPRESERVETHEQUALITYOFYOURSTOPWATCH



■

LIQUIDCRYSTALPANEL

＊

CHECK

Be sure to have the gasket and push-pin replaced with

Specify “SEIKO GENUINE PARTS”

After checking the watch, adjustment or repair may be

required.

new ones by a SEIKO DEALER after the watch is

adjusted or repaired.

when replacing the parts.

It is recommended that the stopwatch be checked every

time the battery for the stopwatch is replaced with a

new one or once every 2 to 3 years . We suggest that

you have your watch checked by a SEIKO DEALER

when the battery is replaced, for oil condition, battery

electrolyte leakage or damage due to water or sweat.

STATIC ELECTRICITY

CHEMICALS

The IC (Integrated Circuit)

used in your watch will be

affected by static electricity,

which may disturb the display.

Keep your watch away from

close contact with suchobjects

as TV screens which emit strong

static electricity.

As plastic materials are

used for the watch case,

be careful not to expose

the watch to solvents

( such as alcohol and

gasoline), cosmetic

spray, detergent, adhe-

sives or paints, as the

case, bracelet, etc. will

be discolored, deterio-

rate or deform through

the chemical action.

After about 7 years of use digital display

panel will decrease in contrast, becoming

difficult to read. Have the panel replaced

with a new one by the retailer from whom

your watch was purchased or an

AUTHORIZED SEIKO DEALER. The

panel will be replaced at cost.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Seiko S351 in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Seiko S351 Manual

Product: