648040
2
Zoom out
Zoom in
Previous page
1/9
Next page
2
1.1
1
4.2
4.1
3
Sedan Hatchback SUV
2.1
2
4
3.1
4.3
!
1.1: Desserrez le CORPS en tournant complètement la MOLETTE
dans le sens inverse des aiguilles d’une montre, jusqu’à ce qu’elle
se bloque. Les composants doivent être lâches et les bras doivent
pouvoir bouger sans contrainte, individuellement l’un de l’autre.
4.1: Placez le porte-vélos sur le véhicule.
4.2: Positionnez le PATIN DU PIED SUPERIEUR sur le dessus du
coffre (comme illustré), de sorte que la tige inférieure soit
perpendiculaire au sol.
4.3: Le centre du CORPS doit être bien équilibré, face externe sur
le pare-chocs.
3.1. En vous aidant de l'illustration qui correspond le mieux à
l'arrière de votre véhicule, ajustez la TIGE SUPERIEURE afin de
mettre le porte-vélos en place.
2.1: Relevez les BRAS du porte-vélos jusqu’à leur enclenchement.
DESSERREZ LA MOLETTE EN PLASTIQUE
EVALUEZ LE TYPE DE VEHICULE
RELEVEZ LES BRAS
Berline Bi-corps Utilitaire sport
AJUSTEZ L'ANGLE DU PORTE-VELOS
1.1: Afloje el CUERPO CENTRAL girando el MANDO DE DESACOPLE
completamente en sentido contrario a las agujas del reloj hasta
que se detenga. Los componentes deben quedar sueltos y los
brazos se deben mover libremente de forma individual.
4.1: Coloque el portabicicletas sobre el vehículo.
4.2: Coloque el APOYO DEL PIE SUPERIOR sobre el portamaletas
(como se indica) de modo que la pata inferior quede
perpendicular al suelo.
4.3: El centro del CUERPO CENTRAL debe quedar en la
perpendicular del borde exterior del parachoques.
3.1. Atendiendo a la ilustración que más se asemeje a la parte
posterior de su vehículo, ajuste la PATA SUPERIOR para colocar el
portabicicletas.
2.1: Levante los BRAZOS del portabicicletas hasta que se fijen en
su posición.
AFLOJAR EL CASQUILLO DE PLÁSTICO
DETERMINAR EL TIPO DE VEHÍCULO
LEVANTAR LOS BRAZOS
AJUSTAR EL ÁNGULO DEL PORTABICICLETAS
Sedán Ranchera Todoterreno
1.1: Loosen the CENTER BODY by turning the RELEASE KNOB
completely counter-clockwise until it stops. Components
should be loose and arms should individually move freely.
4.1: Lift rack onto vehicle.
4.2: Position UPPER FOOT PAD on trunk deck (as shown) so
that lower leg is perpendicular to ground.
4.3: Center of CENTER BODY should be even with outside face
of bumper.
3.1. Following the illustration that most resembles the rear of
your vehicle, adjust UPPER LEG to position carrier.
2.1: Raise bike rack ARMS until they snap into place.
LOOSEN PLASTIC HUB
ASSESS VEHICLE TYPE
RAISE ARMS
ADJUST ANGLE OF RACK
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saris Bike Porter Trunk - 2 Bike at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saris Bike Porter Trunk - 2 Bike in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info