609460

Nilfisk-ALTO SCRUBTEC R 466 Manual

82
Zoom out
Zoom in
Previous page
1/124
Next page
ENGLISH USER MANUAL
20 SCRUBTEC R 466 - R 471 - R 471C - BOOST
®
R4 9098960000(1)2011-04 A
Battery discharge during operation
Until the green warning light (62) stays on, the batteries allow the machine to work normally.1.
When the green warning light turns off and fi rst the yellow warning light then the red warning light turn on, the batteries must
be charged.
When the yellow warning light turns on the machine residual autonomy will last for a few minutes (depending on the •
characteristics of the battery).
When the red warning light turns on the machine autonomy is over: after a few seconds the brushes/pad-holders are •
automatically stopped and the deck is automatically lifted. Only vacuum and drive systems still operate, just to dry the wet
fl oor and move the machine to the appointed charging area.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
NOTE
In case the machine drive system cannot be used in order to move the machine, see Pushing/Towing The Machine
paragraph.
TANK EMPTYING
An automatic fl oat shut-off system (27) turns off the vacuum system when the recovery tank (19) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the fl oor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the fl oat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the switch (65), then
open the cover (20) and check that the fl oat inside the grid (27) has gone down to the water level. Then close the
cover (20) and turn on the vacuum system by pressing the switch (65).
When the recovery tank (19) is full, empty it according to the following procedure.
Recovery tank emptying
Stop the machine by releasing the pedal (4).1.
Lift the brush/pad-holder deck and the squeegee by pressing the pedal (63).2.
Drive the machine to the appointed disposal area.3.
Empty the recovery tank with the hose (24).4.
Remove the container with debris collection grid (26), empty it and clean it with clean water. Then install it on the suction hose 5.
in the tank.
Then, rinse the tank with clean water.6.
Solution/clean water tank emptying
Perform steps 1 to 3.7.
Remove the adapter (45) from its housing inside the battery compartment.8.
Install the adapter (A, Fig. 6) on the squeegee vacuum hose (B), then fasten it to the drain tap (C).9.
Turn the ignition key (58) to “I” and turn on the vacuum system with the switch (65).10.
Open the drain tap (C) to drain the tank (22).11.
The tap (C) is open when it is in the position (D) and it is closed when it is in the position (E).
Then, turn of the vacuum system and drain the recovery tank (19) with the hose (24).12.
When the procedure is over, close the drain tap (C), remove the adapter (A) and install the vacuum hose (B) on the squeegee 13.
(30).
A
B
C
E
DC
Figure 6
P100440
9098960000(1)2011-04 A.indb 209098960000(1)2011-04 A.indb 20 07/04/2011 15:59:2107/04/2011 15:59:21
… 82 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO SCRUBTEC R 466 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO SCRUBTEC R 466 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info