672474
25
Zoom out
Zoom in
Previous page
1/25
Next page
25
Troubleshooting
If you have any further questions, please contact your authorised dealer on site.
All information, diagrams and specifications in these operating instructions are based on the latest product information
at the time of going to press. We reserve the right to make changes without prior notice.
Engine has no power or stops during cutting
Cause Procedure
Cutting head entangled with grass Stop the engine and clean the cutting attachment.
Dirty air filter Clean or replace air filter.
Old or incorrectly mixed fuel Empty the tank/fill with fresh fuel mixture.
Carburettor incorrectly adjusted Have carburettor adjusted by customer service personnel.
Cutting head does release line
Cause Procedure
Cutting head entangled with grass Stop the engine and clean the cutting attachment.
No line in the cutting head Wind up new line.
Coil jammed Replace coil.
Cutting head dirty Clean coil and coil housing.
Line fused together Pull apart, take out the fused part and wind up the line
again.
Line twisted when wound up Pull apart and wind up the line again.
Not enough line released Tap the bump head and pull out the line until 10 cm of line
is outside the cutting attachment.
25


Need help? Post your question in this forum.

Forumrules
1

Forum

mtd-827-series

Reset search

  • Comment retirer sur la debroussailleuse MTD827 le boîtier fil et remplacer pour la lame. Submitted on 29-10-2022 at 14:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD 827 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD 827 series in the language / languages: English as an attachment in your email.

The manual is 2,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD 827 series

MTD 827 series User Manual - German - 27 pages

MTD 827 series User Manual - Dutch - 26 pages

MTD 827 series User Manual - French - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info