773588
6
Zoom out
Zoom in
Previous page
1/7
Next page
Before first use, charge the battery until the charging
indicator turns to green.
Do not let the battery run down completely, as this shortens
the battery’s service life.
Thescreenwillshow<<ch-->>,whenpressingtheON/OFF
button during the charging process. This device cannot be
operated when being charged.
6. Error Messages
If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «X 3 », is displayed.
The pulse signals on the cuff are too
weak.Re-positionthecuff(see2.1)
and repeat the measurement.*
ErrorError
«X 1»
Description
Signal too
weak
Error signal
No pressure
in the cuff
«X 2»
«X 3»
The pulse is too low (less than
40beatsperminute).Repeatthe
measurement.*
«X 5»
«HI»
«LO»
Invalid
result
Pulse or cuff
pressure too
high
Pulse too
low
4
* Please contact your dealer if the error persists.
7. Safety, Care, Accuracy Test and Disposal
Safety and protection
Thisdevicemaybeusedonlyforthepurposedescribedinthis
instruction manual. The manufacturer cannot be held liable for
damage caused by incorrect application.
Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device
and keep for future reference.
Thisdevicecomprisessensitivecomponentsandmustbetreated
with caution. Observe the storage and operating conditions
described in the «Technical Specifications» section.
Protectitfrom:
waterandmoisture
extremetemperatures
impactanddropping
contaminationanddust
directsunlight
heatandcold
Thecuffsaresensitiveandmustbehandledwithcare.
Onlypumpupthecuffoncefitted.
Do not use this device close to strong electromagnetic fields
such as mobile telephones or radio installations. Keep a
minimum distance of 3.3 m from such devices when using this
device.
Donotusethedeviceifyouthinkitisdamagedornotice
anything unusual.
Neveropenthedevice.
Readtheadditionalsafetyinstructionsintheindividualsections
of this instruction.
The measurement result given by this device is not a diagnosis.
It is not replacing the need for the consultation of a physician,
especially if not matching the patient's symptoms. Do not rely on
the measurement result only, always consider other potentially
occurring symptoms and the patient’s feedback. Calling a doctor
or an ambulance is advised if needed.
Ensure that children do not use the device unsupervised; some
parts are small enough to be swallowed; Be aware of the risk of
strangulation in case this device is supplied with cables or tubes.
Potential cause and remedy
During the measurement, error
signals were detected by the cuff,
caused for instance by movement
or muscle tension. Repeat the
measurement, keeping your arm
still.
No adequate pressure can be
generated in the cuff. A leak may
have occurred. Check that the cuff
is correctly connected and is not too
loose. Repeat the measurement.
The measuring signals are invalid
and therefore no result can be
displayed.
Read through the checklist for
performing reliable measurements
and then repeat the measurement.*
The pressure in the cuff is too
high(over299mmHg)ORthe
pulseistoohigh(over200beats
perminute).Relaxandrepeatthe
measurement.*
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Microlife VSA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Microlife VSA in the language / languages: English as an attachment in your email.

The manual is 0.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info