686373

Kemppi A7 Robot Gun Mount T4 Manual

13
Zoom out
Zoom in
Previous page
1/18
Next page
13
Robot Gun Mount T2, T4© Kemppi Oy 2017 1712
OPERATING MANUAL
12.3 Connecting the helix cable
This section describes how to adjust the TCP.
The parts of the system are depicted in the gure below.
Figure 8: Connecting the helix cable
1
3
5
2
4
6
Proceed as follows:
1. Plug the helix cable (4) into the connector housing (6), using the angled male
connector (5).
2. Plug the ange plug (2) into the torch (3) and the cable assembly (1).
3. Lock both connectors to prevent their accidental disconnection.
4. For the switching function, see the functional diagram (10).
1. Cable assembly
2. Flange plug
3. Gun
4. Helix cable
5. Angled male connector
6. Robot Gun Mount T2
connector housing
13. OPERATION
The device may only be operated by qualied personnel.
Because the robot mount is integrated into the gun’s welding process, the operation
steps are performed after the relevant gun has been installed.
Please observe the operating instructions for the A7 MIG Gun 500-g or the A7 MIG Gun
500-w welding guns, as applicable.
14. UNMOUNTING
Unmounting may only be carried out by specialist personnel. Please make sure that
the shutdown procedures for all components mounted in the welding system are strictly
observed before removal from operation begins.
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, unmounting, and repair work, the
following instructions must be adhered to:
• Switch o the power supply.
• Cut o the compressed air supply.
• Pull the power plug.
Removal from operation depends on the type of welding gun. Please observe the
operating instructions for the A7 MIG Gun 500-g or the A7 MIG Gun 500-w welding guns,
as applicable.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 Robot Gun Mount T4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 Robot Gun Mount T4 in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info