686373

Kemppi A7 Robot Gun Mount T4 Manual

12
Zoom out
Zoom in
Previous page
1/18
Next page
12
Robot Gun Mount T2, T4© Kemppi Oy 2017 1712
OPERATING MANUAL
For fastening robot mount T2 to the robot, a robot
ange (2) is required. It must correspond to the hole pattern
of the robot mount (1) and of the robot.
Proceed as follows:
1. Use the cylinder-head screw (8) to attach the robot
ange (6) to the robot (7).
2. Use cylinder-head screws (9) to attach the robot
mount (5) to the robot ange (6)
3. Use the clamping ring (12) and cylinder-head screw
(13) to attach the bracket (11) to the robot mount
(5).
4. Use the dowel screw (3) and nut (14) to attach the
gun mount (2) to the bracket (11).
12.2 Adjusting the TCP
This section describes how to adjust the TCP.
The parts of the system are depicted in the gure below.
Figure 7: Adjusting the TCP
6
54321
1. M8 nut
2. Dowel screw, 6H7
3. Gun segment holder upper part
4. M6 nut
5. Dowel screw, 8H7
6. Gun segment holder lower part
Proceed as follows:
1. Loosen the nut (1), and adjust the gun mount (3)
to the desired TCP.
2. Tighten the nut (1).
3. To make the position chosen permanent,
proceed as follows:
a. Drill a Ø 5.8 mm bore hole into the bracket
(6), and use a reamer to ream the bore for
the dowel screw (2).
b. Use a dowel screw (2) and a nut (4) to secure
both brackets (6 and 3).
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 Robot Gun Mount T4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 Robot Gun Mount T4 in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info