550946
139
Zoom out
Zoom in
Previous page
1/433
Next page
ENGINE TOP END 4-45
Bevel Gears (Hypo id Gears)
Bevel Gear Case Removal
Drain the engine oil.
Remove:
Cylinder Head Cover (see Cylinder Head Cover Re-
moval)
Rotor Plug (see Camshaft Removal)
Timing Inspection Plug (see Camshaft Removal)
Bring the piston to the TDC.
Timing Notch [A]
TDC Mark [B]
Ignition Mark [C]
Remove the snap ring [A].
Pull the outer pipe [B] down.
RemovetheE-clip[A]
Pull the driveshaft [B] down until the tip of the s haft is
visible.
Special Tool - Outside Circlip Pliers: 57001-144
Remove the clutch cover [A] (see Clutch chapter).
Remove the bolts [B].
Remove the bevel gear case [C].
Bevel Gear Case Installation
Replace the E-clip and the snap ring with new parts, and
fit them in place.
Make sure that there is one knock pin on the crankcase.
Make sure that a spring is installed on the tip of the drive-
shaft.
Apply high-temperature grease to the O-rings [A] and the
rubber gasket [B], and install them on the bevel gear case.
Install the bevel gear case.
If the bevel gear case cannot be installed easily, turn the
driveshaft while installing the bevel gear case.
139


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kawasaki W 650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kawasaki W 650 in the language / languages: English as an attachment in your email.

The manual is 9,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info