28356
37
Zoom out
Zoom in
Previous page
1/148
Next page
Section 2 Installation
36
The procedure to assemble the connector is as follows. Please refer to Figure
2-11.
q Feed the end of the cable through the backshell, rubber grommet and cou-
pling ring in the order and position drawn.
w Strip the cable as shown in Figure 2-10. Begin soldering the conductors to
the connector pins, as shown in the appropriate diagram for the NMEA
connectors. Verify that each connector is firmly soldered and that no stray
wires are shorting adjacent pins.
Figure 2-10
e Slide the coupling ring over the body of the connector and beyond the
locking projections on each side, it may be necessary to rotate the ring
slightly for it to pass by the locking tabs.
r Push the rubber grommet forward as far as possible to seat it snugly against
the connector body.
t Push the backshell all the way forward. It must first compress the rubber
grommet, then be twisted over the (2) locking posts on the connector body.
This is a tight connection. For leverage it may be helpful to first insert and
lock the connector into its mating plug on the RADAR 1800 back panel.
Figure 2-11
4.8 (3/16)
7.9
(5/16)
Diameter 6.4~6.9
(0.25~0.27)
12.7 (1/2) MAX
GROMMET
PIN
CONTACTS
BACKSHELL COUPLING RING CONNECTOR BODY
Unit : mm (inch)
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JRC Radar1800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JRC Radar1800 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info