28356
36
Zoom out
Zoom in
Previous page
1/148
Next page
Section 2 Installation
35
Connecting GPS/DGPS Sensor or Making
NMEA0183 Data Connections (Option)
When displaying the latitude and longitude of your vessel on the screen, or
using the NAVIGATION mode, you are required to connect the optional
GPS112 or DGPS212 sensor to the RADAR 1800, or input the data of
navigational information in the NMEA0183 format from navigation equipment.
Connecting GPS112 or DGPS212 sensor
When using the GPS112 or DGPS212 sensor, connect the 5-pin antenna
connector attached to the signal cable of the sensor to the “GPS” connector at the
rear panel of the unit.
With this, it is possible to receive the necessary data of navigational
information from the GPS112 or DGPS 212 sensor. It is advisable, however, to
perform initial settings according to your conditions using the GPS SETTING,
DGPS SETTING menu of the unit for more precise navigational information.
Refer to p.91 and p.92 for the information about initial settings for each sensor.
Making NMEA0183 data connections
When receiving navigational data information in the NMEA0183 format
from navigation equipment other than this unit, you are required to make a
connecting cable using the 5-pin connector (model 6-282-5SG-325, CONXALL)
and connect it to the “NMEA” connector at the rear panel of the unit.
Connect the 5-pin connector and the connecting cable as shown in Figure
2-9.
Figure 2-9
Locating Dot
Data Input
Data Common
Data
-
OUTPUT
Data + OUTPUT
NMEA 0183 INPUT
NMEA 0183 OUTPUT
Viewed from solder side of connector body
Only the GPS/DGPS sensors manufactured by JRC
can be connected directly to the GPS connector at
the rear panel. If those other than manufactured by
JRC are connected, the equipment may be damaged.
CAUTION
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JRC Radar1800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JRC Radar1800 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info