724186

HP OfficeConnect OC20 Manual

3
Zoom out
Zoom in
Previous page
1/4
Next page
3 OfficeConnect OC20 Access Point | Installation Guide
Installing the Access Point
The OC20 access point ships with a ceiling rail adapter and an
AP-220-MNT-W1W mount bracket. Additional ceiling or wall
mount kits are sold separately as accessories.
Using the Ceiling Rail Adapter
The included ceiling rail adapter can be used to attach the OC20
access point to a 9/16” or 15/16” ceiling rail.
1. Pull the necessary cables through a prepared hole in the
ceiling tile near where the access point will be placed.
2. Place the adapter against the back of the access point with
the adapter at an angle of approximately 30 degrees to the
tabs (see Figure 3).
3. Twist the adapter clockwise until it snaps into place in the
tabs (see Figure 3).
Figure 3 Attaching the Ceiling Rail Adapter to the AP
4. Hold the access point next to the ceiling tile rail with the
mounting slots at approximately a 30-degree angle to the
ceiling tile rail (see Figure 4 and Figure 5). Make sure that
any cable slack is above the ceiling tile.
5. Pushing toward the ceiling tile, rotate the access point
clockwise until the device clicks into place on the ceiling tile
rail.
Figure 4 Mounting the Access Point to a 15/16” ceiling rail
Figure 5 Mounting the Access Point to a 9/16” ceiling rail
Using the AP-220-MNT-W1W Bracket
The included AP-220-MNT-W1W bracket can be used to mount
the OC20 access point to a wall.
1. Begin by attaching the bracket to the wall as shown in Figure
6 or Figure 7.
a. Install any necessary wall anchors. Wall anchors are not
included in the package.
b. Align the screw holes in the bracket with the previously
installed anchors or demarcated screw points.
c. Insert the screws to secure the bracket. Screws are not
included in the package.
Figure 6 Attaching the Bracket to a Wall
Figure 7 Attaching the Bracket to a Wall (Alternate)
2. Attach the AP to the secured bracket as shown in Figure 8.
a. Align the AP with the bracket, placing the AP so that its
mounting tabs are at an angle of approximately 30
degrees to the bracket.
3. Pushing toward the wall, rotate the AP clockwise until it
clicks into place (see Figure 8).
Service to all Hewlett Packard Enterprise access points
should be performed by an AMCP certified technician or
similar.
The installer is responsible for securing the access point onto
the ceiling tile rail in accordance with the steps below. Failure
to properly install this product may result in physical injury
and/or damage to property.
AP-130_003
AP-130_006
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP OfficeConnect OC20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP OfficeConnect OC20 in the language / languages: English as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info