30178
3
Zoom out
Zoom in
Previous page
1/6
Next page
3 4
IV. Setting and Operation
1. Transmitter
a. Loading Batteries
You may use either Alkaline or Nicad "AA" size batteries.
- Push the bottom battery cover in the direction of the arrow then lift up the cover
- Load 8 AA batteries (Be sure the polarity is correct)
- Reinstall battery cover
- Nicds should be charged with the Hitec CG-22 or CG-25A charger for
minimum 12 hours before use
1
2
b. Reading the LED Battery Indicators
- Normal: Green
- Warning: Flashing Red
With new alkaline or freshly charged nicads the Green light should be brightly lit; as the green light starts
to fade the Red will begin to illuminate and eventually light completely as the green light goes out. Once
this occurs, operation should be stopped immediately, and the batteries should be recharged or replaced.
(Warning: Recharge Nicds batteries only. Alkaline batteries can not be recharged)
Alkaline or Nicad "AA"size
GREEN HIGH
LOW
HIGH
LOW
NORMAL WARNING
CG-22A or
CG-25A
(Not included)
RED
GREEN
RED
#7401 RX Nicad Battery
(Not included)
c. Recharging Nicd Batteries
The Lynx Sport is equipped with an external-charging jack so there is no need to remove the batteries from
the transmitter to charge them. The Hitec CG-22 or CG-25A charger can be used to charge the batteries
overnight, or for approximately 12~15 hours.
d. Transmitter Antenna
Always make sure your antenna is attached and fully extended before use otherwise your operating range
will be greatly reduced and could result in damage to your vehicle and or injuries to yourself and others.
e. Changing Crystals
Changing crystals to avoid conflicts with other vehicles is possible where permitted. (You must check your local
rules before doing so. For example in the US the FCC prohibits the changing of transmitter crystals on 75MHz).
If you are eligible to change crystals, both the transmitter and receiver crystals must be changed together.
You must change within the same band; i.e. 75MHz to 75MHz, 27MHz to 27MHz, different bands can not be
intermixed, if your radio is on 75MHz then 27MHz crystals cannot be used. Use only Hitec crystals when
changing frequencies.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitec LINX_SPORT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitec LINX_SPORT in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info