505730
7
Zoom out
Zoom in
Previous page
1/17
Next page
MULTI-AMPLIFIER APPLICATIONS
5
Front/Rear high pass, using a 2 channel amplifier for mono sub bass
2 channel bass amplifier(COLOSSUS PRO is used in the example below):
The combination of a BOLTAR or COLOSSUS PRO and a JUPITER
- X-OVER switch: LP/BP
amplifier, utilizing their built in crossovers, makes it a snap to put together a
full system with front and rear highs, with mono sub bass.
- PARAMETRIC EQ FREQUENCY: X1
- CROSSOVER FREQUENCY: X1
Interconnect cable checklist:
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
Please note that these frequency points are suggestions only. Refer to the
the inputs of the 4 channel JUPITER as shown.
loudspeaker manufacturer specifications and the section “Setting up systems
after installation for best performance”
- Also connect the LINE OUT of the JUPITER to the LINE INPUT of the 2
channel COLOSSUS PRO amplifier as shown.
Level control checklist:
Mono bass woofer wiring:
- Refer to the section “Setting up systems after installation for best performance”
Connect the mono speaker positive terminal to the LEFT +, and its negative
terminal to RIGHT -.
Minimum final loudspeaker impedances:
TITAN:
Switch setting checklist:
- 2-Ohm per channel in stereo mode.
4 channel highs amplifier:
- 4-Ohms mono bridged.
- 1/2CH X-OVER: HP
COLOSSUS PRO:
- PARAMETRIC EQ FREQUENCY: X10
- CROSSOVER FREQUENCY: X10
- 1-Ohm per channel in stereo mode.
- 2-Ohms mono bridged.
- 3/4CH X-OVER: HP
JUPITER:
- PARAMETRIC EQ FREQUENCY: X10
- CROSSOVER FREQUENCY: X10
- 2-Ohms per channel in stereo mode.
- 4-Ohms mono bridged.
STEREO
INTERCONNECT
RCA CABLE
BATT+12V
GROUND
SPEAKER OUTPUT
RIGHT LEFT
REM + - + -
BRIDGED
REMOTE TURN-ON
DUAL CHASSIS GROUND
DUAL BATTERY +12v
VIA FUSE
MONO SPEAKER
or SUBWOOFER
LL
RR
HFR-G1
REMOTE
SUBSONIC FREQUENCY BANDWIDTH CUT/BOOST
FREQUENCY RIGHT LEFT INPUT LEVEL
PARAMETRIC EQ
PHASE
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HP LP/BP
FULL RANGE
X1 X10
FULL RANGE
OUTPUT
LINE
INPUT
15Hz 150Hz 40Hz 400Hz Narrow Wide -10dB +10dB
40Hz 400Hz 0 180 0 180 9V 0.2V
X1 X10
LP/BP
STEREO 12dB/OCT
MONO 24dB/OCT
LP DIRECT
POWER INPUT
GND REM BATT+12V
CH 1/2 SPEAKER OUTPUT CH 3/4
RIGHT LEFT RIGHT LEFT
- + - + - + - +
BRIDGED BRIDGED
HFR-G1
REMOTE
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HP LP/BP
CROSSOVER
PARAMETRIC EQ
PARAMETRIC EQ
HP
FULL RANGE
FULL
X1
X1
4CH
MODE
X1
X1
X10
X10
2CH
X10
X10
LINE INPUT
CH 3&4
CH 1&2
FREQUENCY FREQUENCY BANDWIDTH BOOST SUBSONIC LEVEL
40Hz 400Hz 40Hz 400Hz NARROW WIDE -10dB +10dB 15Hz 150Hz 9V 0.2V
40Hz 400Hz 40Hz 400Hz NARROW WIDE -10dB +10dB 9V 0.2V
FREQUENCY FREQUENCY BANDWIDTH BOOST LEVEL
4Ch
MONO MIX
OUTPUT
Ch1 Ch3
Ch2 Ch4
FUSE
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics MT OLYMPUS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics MT OLYMPUS in the language / languages: English as an attachment in your email.

The manual is 6,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info