479858
8
Zoom out
Zoom in
Previous page
1/8
Next page
PAG. 14
PAG. 15
REPLACEMENT OF DEVICE BATTERIES
The use of batteries which are different from the suggested one, could
provoke irremediable damage to the device.
Do not waste the environment with exhausted batteries, but use for their
disposal the specific waste containers.
MAGNETIC CONTACT
The led's light intensity indicates the battery charge state of the magnetic
contact:
! Intermittent light or low intensity of the led: uncharged battery.
! Permanent light or high intensity of the led: charged battery.
To replace the batteries, proceed as follows:
! With the alarm being disarmed, open the cover of the magnetic contact.
! Remove the exhausted batteries and replace with new, being careful to not
invert the polarity.
! Put back the cover of the magnetic contact.
ATTENTION: use only batteries of CR1616 type.
LITHIUM BATTERY
CR1616
3V
LIT
TRANSMITTER
The radio control is equipped with a device which indicates the battery charge
status.
During normal operating of the radio control, when pushing the control button,
the green led will be permanently illuminated.
If the battery charge status is under the level required for good operating,
when pushing the system arming/disarming button, the green led will be
flashing in order to warn the user that battery replacement is needed.
In this case, open the radio control with a light pressure between the two shells
and then replace the batteries.
ATTENTION: use only batteries of CR1616 type.
BATTERIE OF CR 1616 TYPE
WARRANTY CONDITIONS
This apparatus is guaranteed against all defects of fabrications for a period of 24
month from the installation date shown on this warranty coupon, taking into
consideration the 1999/44/CE.
Therefore, you are kindly requested to fill entirely the guarantee certificate included
in this booklet and to NOT REMOVE the guarantee label from the device.
Missing or tearing of this label, missing of one part of guarantee certificate or
missing of the enclosed sale document, will invalidate the guarantee. The
guarantee is valid exclusively to Gemini Technologies S.p.A. Authorized Service
Centers.
The manufacturer will decline any responsibility for any eventual malfunctions of the
device, or electrical plant damages of the vehicle, due to improper installation, use
or tampering.
This alarm has exclusively a deterrent function against eventual thefts.
Figura 1
Figura 2
BATTERY REPLACEMENT
Open the TAG's plastic, making level with a screwdriver on the hole close to the
slot. (Figure 1)
Remove the circuit and pull out the uncharged battery; position the charged
battery, keeping the negative pole upwards. (Figure 2)
Remount all components, being sure that closure is correct and efficient.
:Note: in order to achieve longer life of the battery, it is suggested to turn off the
device, when it is not used.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Gemini 7563 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Gemini 7563 in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info