580132
3
Zoom out
Zoom in
Previous page
1/9
Next page
UN PROBLEME ?
5
N’hésitez pas à nous appeler sur notre ligne d’assistance téléphonique (tel en fin de notice).
Nos techniciens se feront un plaisir de vous aider à parfaire votre installation.
10. Battery Compartment
For 4 x D-cell Alkaline Batteries.
11. Phone jack marked “Line”
This jack is for the connection to the phone line
from the wall.
12. Phone jack marked “Phone”
This jack is for the connection to the Telephone
unit.
13. Device Connection Terminal
The 2-Pin Device Connection Terminal is for
connecting to wired detectors
II. The Power Supply
CTC-729G Auto Dialer features completely wire-free
operation and uses four alkaline D cells. The battery-
life is estimated for 2 years or more.
Battery Insertion:
The battery compartment is a large box in the Control
Panel with a lid secured with 1 screw.
Remove the screw and take off the
compartment lid.
Insert the D cell alkaline batteries provided
into the battery compartment, taking care to
put the batteries in the right way around.
The unit will give a long beep when the last
battery is inserted.
Replace the battery compartment with the
screw taking care not to over tighten
Close the lid and tighten the large lid fixing
screw with a coin.
III. Connecting the telephone line
Two telephone jacks can be found from the rear for the
connection of your telephone line and telephone set.
Remove the Wall Mounting Bracket as
shown.
Plug one end of the enclosed telephone cable
into the socket jack on the wall.
Plug the other end of the enclosed telephone
cable into the socket marked “Line”.
Plug your telephone set into the other socket
marked “Phone”.
IV. Device Connection Terminal
Pin 1 provide Dry Contact input for wired
detector
For wired PIR detectors, Door Contact, Water
detectors, Panic buttons and Broken Glass
detectors, connect Pin 1 to Pin 2
To Set Terminal Polarity
The polarity of the Device Connection Terminal can be
set following these steps:
Step 1.
Press key when the Dialer is in
Normal Mode to enter Programming
mode.
The YELLOW LED will flash.
Step 2. Enter “Pin Designated Number”
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eden HA2000 RTC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eden HA2000 RTC in the language / languages: English as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eden HA2000 RTC

Eden HA2000 RTC User Manual - German - 9 pages

Eden HA2000 RTC User Manual - Dutch - 10 pages

Eden HA2000 RTC User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info