534681
67
Zoom out
Zoom in
Previous page
1/68
Next page
Dimension BST 768 / SST 768 User Guide
Troubleshooting 67
C. With the glue brush provided in the Startup Kit, clear any
material buildup from each drive by brushing its serrated
drive wheel.
13. Check for Extrusion.
A. Press Forward.
Pull out 6 inches of material from the fixed head housing.
Feed the filament into the drive blocks and look at the tips
to verify material is extruding through both liquefiers.
B. If the filament does not extrude:
i. Stop the motors and return to Step 4.
ii. If, after two tries the material fails to extrude, call your
service provider.
C. If the purge was successful, continue to run both filament
motors forward and slowly swivel the head closed.
D. Once the head is closed, tighten both ¼ turn screws.
E. Verify material continues to extrude through both tips for
an additional 30 seconds, and then press Stop to halt
extrusion.
F. Push Done. The panel displays Is material loaded?
G. Press Yes. The panel displays Exiting maintenance
and you can resume normal operation.
IMPORTANT
While closing the head, be careful not to
crimp the filament, and make sure that
the head wiring doesn’t get pinched
between the swivel head and the rear
head housing.
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension SST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension SST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info