534681
66
Zoom out
Zoom in
Previous page
1/68
Next page
66 Troubleshooting
Dimension BST 768 / SST 768 User Guide
support liquefier inlet tube under the inlet funnel. Do
not remove this material unless it interferes with
reinstallation of the inlet funnel.
d. Inspect for damage to the support inlet tube.
e. Replace the liquefier inlet funnel.
Figure 24: SST - Inspecting the support liquefier inlet funnel and model
liquifier inl
9. Clean the inside of the liquefier inlet tubes.
Carefully insert a 1/16” Allen wrench into the liquefier inlet
tubes and gently push forward until it stops (about 1/4 inch).
10. Replace both drive-block assemblies.
Install the model drive block assembly first. Make sure the
block is seated flush against the swivel plate.
11. Repeat for the support drive block assembly.
12. Clean the drive wheels.
A. Press Select Drive repeatedly until the display shows
Both Drive Motors.
B. Press Reverse.
IMPORTANT
Be careful not to pinch the assembly’s
wiring harness under the block or behind
the motor before replacing and
tightening the mounting screws.
SST Support Liquefier Inlet
Funnel
(shown with only the support
drive block removed)
SST Model Liquefier Inlet
Tube does not have a funnel.
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dimension SST 768 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dimension SST 768 in the language / languages: English as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info