687412

DeLonghi Dinamica ECAM 350.75.S Manual

21
Zoom out
Zoom in
Previous page
1/27
Next page
20
17.1 Installing the lter
34
1. Remove the lter (C4)
from the packaging. The
date indicator disk varies
according to the lter
provided.
2. Turn the date indicator
disk (g. 34) until the
next 2 months of use are
displayed.
Please note
The lter lasts about two
months if the appliance is
used normally. If the coee
machine is left unused with the lter installed, it will last a max-
imum of three weeks.
3. To activate the lter, run tap water through the hole in the
lter as shown in g. 35 until water comes out of the open-
ings at the side for more than a minute.;
35 36
0,5 L
4. Extract the tank (A17) from the appliance and ll with
water;
5. Insert the lter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (g. 36).
6. Insert the lter in the lter housing (A18) and press as far
as it will go (g. 37);
7. Close the tank with the lid (A16) (g. 38), then replace the
tank in the machine;
37 38
When you install the lter, you must notify the appliance of its
presence.
8. Press (B6) to enter the "Settings" menu;
9. Press the selection arrows (B2 and B4) until "Maintenance"
is displayed between the two lines. Press OK;
10. Press the selection arrows until "Install lter" is displayed,
then press OK;
11. Conrm?": press OK;
12. "Hot water, Conrm?": Position a container under the hot
water spout (C6) (min. capacity: 500 ml), then press OK;
13. The appliance begins hot water delivery and the message
"Please wait" is displayed;
14. After the ow of hot water stops, the appliance automati-
cally resets to "Ready for coee" status.
The lter is now active and you can use the coee machine.
17.2 Replacing the lter
Replace the lter (C4) when "Replace lter, ESC to cancel, OK to
replace" appears on the display (B1). To replace immediately,
press OK (B3) and follow the instructions from point 8. To re-
place later, press ESC (B5). The symbol on the display reminds
you that the lter needs replacing.
To replace the lter, proceed as follows:
1. Extract the tank (A17) and exhausted lter;
2. Take the new lter out of its packet and proceed as illus-
trated in points 2, 3, 4, 5, 6 and 7 in the previous section;
3. Press (B6) to enter the "Settings" menu;
4. Press the selection arrows (B2 and B4) until "Maintenance"
is displayed between the two lines. Press OK;
5. Press the selection arrows until "Replace lter" is dis-
played, then press OK;
6. Conrm?": press OK;
7. "Hot water, Conrm?": Position a container under the hot
water spout (C6) (min. capacity: 500 ml), then press OK;
8. The appliance begins hot water delivery and the message
"Please wait" is displayed;
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi Dinamica ECAM 350.75.S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi Dinamica ECAM 350.75.S in the language / languages: English as an attachment in your email.

The manual is 8.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi Dinamica ECAM 350.75.S

DeLonghi Dinamica ECAM 350.75.S User Manual - German - 28 pages

DeLonghi Dinamica ECAM 350.75.S User Manual - Dutch - 21 pages

DeLonghi Dinamica ECAM 350.75.S User Manual - French, Italian - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info