652347
52
Zoom out
Zoom in
Previous page
1/56
Next page
52
6.6.5 Resetting fault indication (red LED lit)
In order to return the steam humidifier to operation after fault elimination (Error), the steam humidifier
must be switched off for approx. 5 seconds and then switched on again.
Note: Resetting maintenance indication see chapter 6.5.5.
6.6.3 Instructions for fault elimination
When eliminating faults, the steam humidifier must be taken out of operation (see
chapter 6.4).
Warning danger of death! Take care that the electricity supply to the main
contactor is cut off (test with voltage tester).
Repair work and replacement of faulty components may only be carried out by
your Condair representatives service technician or personnel authorized to do
the work!
Warning! Malfunctions relating to the electrical installation must only be
repaired by authorized personnel.
Electrical components are very sensitive to electrostatic discharge. Measures must
be taken to protect these components against electrostatic discharge during all repair
work (ESD protection).
Only use original spare parts from your Condair supplier for the replacement of faulty
components.
Warning: Danger of death! Before changing the unit fuse, the steam humidifier must be
switched off and secured against unintentional reconnection as described in chapter 6.4.
Take care that the electricity supply to the main contactor is disconnected (check with voltage
tester).
Important! If the fine-wire fuse on the control print blows this is usually due to a faulty coil of the inlet
or drain valve or the main contactor. Therefore you should test these components before replacing the
fuse.
Only use fuses of the given type with the specified nominal current strength to
replace the fuse
Warning! It is not permitted to use repaired fuses or to short-circuit the fuse holder.
6.6.4 Replacement of fine-wire fuse on the control print
models N4/H4
all other models
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Condair CP2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Condair CP2 in the language / languages: English as an attachment in your email.

The manual is 3,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info