652347
51
Zoom out
Zoom in
Previous page
1/56
Next page
51
Main contactor jammed in activated position. Check/replace main contactor.
Rotary switch on control PCB is set to position TEST. Set rotary switch to the position for the corresponding
steam cylinder type (see Electric-Installation Condair
CP2/Module M..).
CP2-Chip not installed on control board . Install CP2-Chip (see chapter 5.5.2 Inserting CP2-
chip) or contact your Condair supplier.
No sensor signal present, humidity sensor defective. Check/replace humidity sensor.
Humidity to high/too low.
Inspect ventilation system.
Phase failure heating voltage.
GFCI activated.
Current/peak-current cut-off.
Water supply obstructed, water pressure too low, inlet
valve defective.
Drain valve is leaking.
Fine-wire fuse on control PCB open due to faulty coil.
Turn on mains service switch, Inspect main fuses and
replace if applicable.
See Electric-Installation Condair CP2/Module M...
See Electric-Installation Condair CP2/Module M...
Open shut-off valve, clean water inlet filter, check
water pressure, inspect/replace inlet valve.
Clean/replace drain valve.
Check valve/contactor coils and replace if applicable.
Replace fine-wire fuse.
Faulty auto-drain function.
Faulty drain valve/coil.
Steam cylinder outlet obstructed.
Water conductivity too high for type of steam cylinder.
Inspect installation/control system.
Replace drain valve/coil.
Clean/replace steam cylinder.
Select correct steam cylinder type.
Units turned off or defective.
Open BUS connection between basic units.
The number of basic units does not match the number
of units memorized on the CP2-chip.
Switch on/repair units.
Reestablish BUS connection.
Insert correct CP2-chip (see chapter 5.5.2 Inserting
CP2-chip).
Cause Remedy
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Condair CP2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Condair CP2 in the language / languages: English as an attachment in your email.

The manual is 3,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info