507735
24
Zoom out
Zoom in
Previous page
1/28
Next page
24
12 Wartung und Gewährleistung
Im Allgemeinen ist der ATAG-Solarspeicher wartungfrei. Der Druck der Kollektoranlage
und der Schutz durch das Glykol-/Wassergemisch ist jedoch alle zwei Jahre zu
kontrollieren.
Das Verhältnis des Glykol-/Wassergemisches kann mit einem Refraktometer gemessen
werden. Geben Sie hierzu einen Tropfen des Gemisches auf die Glasplatte. Schließen
Sie die Kappe und lesen Sie die Propylenskala im Fenster ab.
Der Druck muss mindestens 2 bar betragen.
Der pH-Wert der Kollektorflüssigkeit muss mindestens 7 betragen. Er kann mit pH-
Teststreifen gemessen werden, die bei Kontakt mit der Flüssigkeit die Farbe wechseln.
Beschädigungen des Speichers, des Kollektors und der SolarStation sowie der zwischen
diesen Komponenten verlaufenden Leitungen in Folge von Frost sind von der
Gewährleistung ausgenommen.
13 Störungen
Störung Ursache Lösung
Über 50 °C Differenz zwischen
Kollektor und Speicher, obwohl
die Temperatur im Speicher noch
keine 80 °C beträgt.
Luft in der Anlage
Anlage mit einem Pumpenwagen
spülen
Leitungswiderstand zwischen
Kollektor und Pumpe ist zu groß
Passen Sie die Pumpeneinstellung
oder die Leitungen an
Pumpe defekt Pumpe austauschen
Druck zu niedrig
Undichtigkeit im sonnenseitigen
Anlagenkreis
Undichtigkeit beseitigen
Ausdehnungsgefäß defekt Ausdehnungsgefäß austauschen
Druck steigt bei Erwärmung des
Kollektors stark an
Ausdehnungsgefäß defekt Ausdehnungsgefäß austauschen
Vorratsspeicher ist heiß, das
ausströmende Wasser aber ist
kalt
Mischventil defekt Mischventil austauschen
Pumpe ruckelt/stottert Pumpeneinstellung anpassen
wird auf dem Bildschirm der
SolarStation angezeigt
Maximale Kollektortemperatur
erreicht
Keine Maßnahmen erforderlich, die
Pumpe wurde abgeschaltet
und werden auf dem
Bildschirm der SolarStation
angezeigt.
888.8 = Fühler defekt
Überprüfen Sie das Kabel und
tauschen Sie gegebenenfalls den
Fühler aus
- 88.8 = Kurzschluss des Fühlers
und werden auf dem
Bildschirm der SolarStation
angezeigt
Pumpe auf manuell Ein oder Aus
eingestellt
Pumpe in Automatikmodus schalten
wird auf dem Bildschirm der
SolarStation angezeigt
Maximale Speichertemperatur
erreicht
Keine Maßnahmen erforderlich, die
Pumpe wurde abgeschaltet
Anlagendruck ist auf 3 bar
gestiegen
Speicher eventuell defekt An den Hersteller wenden
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATAG CBHotTop at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATAG CBHotTop in the language / languages: German as an attachment in your email.

The manual is 1,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATAG CBHotTop

ATAG CBHotTop Usermanual and installation guide - Dutch - 20 pages

ATAG CBHotTop Installation Guide - Dutch - 28 pages

ATAG CBHotTop User Manual - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info