544959
3
Zoom out
Zoom in
Previous page
1/4
Next page
Lösen Sie vorsichtig die 2 Torx-
Schrauben der Zierblende, die
um das Radio und die Regler sitzt.
Beim lösen der Zierblende halten
Sie sich unbedingt an die vorgege-
bene Reihenfolge. Erst die rechte
Seite, dann die linke Seite.
Unscrew both Torx head screws
at the upper left and right side
of the trim part. Then remove the
U-shaped trim cover exactly in
the sequence as shown in the pic.
Start at the upper right end and
work towards the bottom and
around.
7
Lösen Sie dann die 4 Torx-Schrau-
ben, die das Radio fixieren und
ziehen Sie das Gerät heraus.
Unscrew the four Torx head screws
that fix the radio to the dashboard.
Pull the head unit out.
8
Lösen Sie die Verankerung des
MOST-Steckers und ziehen Sie
diesen Hebel nach oben.
The MOST plug on the backside of
the head unit can be unlocked by
lifting the lever up towards the
wires.
9
Ziehen Sie nun den MOST-Stecker
vom Gerät. Lösen Sie nun noch
die zwei Antennenstecker.
Pull out the MOST plug and also
remove the two antenna plugs.
bl
Der Radio-Schacht ist nun frei.
Es kann mit der Montage des
ZE-MC2000 begonnen werden.
Gehen Sie dazu in umgekehrter
Reihenfolge dieser Einbauanleitung
vor. Verbinden Sie den weissen
Antennenstecker mit dem Antennen-
anschluss des ZE-MC2000. Stellen
Sie sicher, das Sie alle benötigten
Kabel der Media-Link-Box oder der
Rückfahrkamera angeschlossen
haben. Der Anschlussplan gibt Ihnen
Auskunft über weitere Anschluss-
möglichkeiten.
The dashboard is now ready for
the install of the ZE-MC2000.
For ZE-MC2000 installation apply
the same steps as described above
but in reversed sequence. Connect
the white antenna plug to the
antenna port on the ZE-MC2000.
Check the wiring diagram overleaf
to see, how to connect a rear view
camera or media-link box.
bm
1
2
3
4
7
8
9
bl
bm
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zenec ZE-MC2000 MOUNTING INSTRUCTIONS GOLF V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zenec ZE-MC2000 MOUNTING INSTRUCTIONS GOLF V in the language / languages: English, German as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info