544959
2
Zoom out
Zoom in
Previous page
1/4
Next page
MOUNTING INSTRUCTIONS
2
Nachdem das Gitter abgenommen
wurde, trennen Sie den Stecker von
der Unterseite des Gitters.
After the metal mesh has come off,
proceed with unplugging the
connector underneath.
Hebeln Sie vorsichtig das Gitter
heraus. Beginnen Sie an der zur
Scheibe zugewandten Seite.
Lever up the metal mesh top cover.
Start with the side that is close to
the windshield.
1
Lösen Sie die Torx-Schraube. Unscrew the Torx head screw in the
center.
3
Hebeln Sie die Lüftungsarmatur nur
an der zur Scheibe zugewandten
Seite heraus. Drücken Sie dann die
Armatur vorsichtig nach oben.
Pull up the A/C plastic main frame
at the end that is nearest to the
windshield. Carefully push the A/C
assembly upwards.
6
Ihr Fahrzeug ist mit einem elektro-
nischem Eigendiagnose-System (DME)
ausgestattet. Um unbeabsichtigte
Fehlermeldungen zu vermeiden, trennen
Sie bitte unbedingt vor Montagebeginn
den negativen Pol von der Batterie. Für
einen optimalen Halt montieren Sie die
beiliegenden Führungsschienen (No.11)
mit den entsprechenden Schrauben
(No.10) gemäß Packliste.
Verbinden Sie den CAN-Bus Adapter
(Abbildung ähnlich) an den vorge-
sehenen Stecker.
Tampering with the on-board electrical
system might cause an error code
to be stored in the DME. It is thus
recommended to disconnect the GND
wire of the negative battery pole before
you start any installation work.
For best stability of unit inside the
dashboard, please mount the die-cast
rails (No.11/packing list), using the
appropiate screws (No.10/packing list).
Bevor Sie beginnen: Before you start:
Montage:
Hebeln Sie nun vorsichtig das innere
Plastikteil aus der Verankerung.
Beginnen Sie an der zur Scheibe
zugewandten Seite.
Carefully lift the inner plastic part
out of its seating.
Here as well, start with the end
closest to the windshield.
4
Lösen Sie die zwei Torx-Schrauben. Unscrew the two Torx head screws.
5
1
3
2
6
4
5
Installation:
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zenec ZE-MC2000 MOUNTING INSTRUCTIONS GOLF V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zenec ZE-MC2000 MOUNTING INSTRUCTIONS GOLF V in the language / languages: English, German as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info