539658

Zelmer Cito VC1200 Manual

37
Zoom out
Zoom in
Previous page
1/38
Next page
41
VC1200-001_v02
It is normal for the AC adaptor to become hot
during charging.
6
A charging cycle lasts from 6 to 8 hours. After the
charging has been completed, the indicator light on the AC
adaptor should change from red to green, indicating that the
battery has been charged.
It is recommended to continue the charging for another 1-2
hours.
After charging the battery, unplug the AC adaptor.
●
To make sure that the vacuum cleaner is ready to
●
use when needed, it is recommended to keep it in the
charging station when not in use.
With fully charged batteries, the maximum cleaning time
●
is 20 minutes.
To ensure maximum performance, the battery
should be fully discharged and then recharged
for at least 12 hours after each of the rst three
charging cycles. Further chargings should be
carried out as described above.
In case of voltage drop, the appliance will turn
off automatically. Ensure that appliance is
charged before use.
End of work, cleaning and maintenance
CLEANING THE DUST CONTAINER AND FILTER
UNIT
1
Press the release button and pull down gently to remove
the container.
2
Remove the “CYCLONE” container from the dust
container together with the HEPA lter. To do so, hold the
handle of the lter unit and pull it out of the dust container.
3
Empty the dust container, removing the debris collected
inside.
4
Clean the inside of the dust container with warm water,
then dry with a cloth.
Clean the dust container after each use.
5
Remove the HEPA lter from the lter unit.
If clogged, the HEPA lter should be cleaned or
replaced with a new lter.
6
Clean the pleats of the HEPA lter. This can be by
rinsing under running water. Dry the lter thoroughly before
replacing.
If the pleats are damaged, it is essential to replace the lter
with a new one.
7
Open the cover on the “CYCLONE” container. Empty the
container and clean the cone. The “CYCLONE” container is
suitable for rinsing under running water. Dry the container
thoroughly before replacing.
E
8
After drying the HEPA lter and the „CYCLONE”
container, t both elements together. To do so, replace the
HEPA lter and insert the lter unit into the dust container.
For safety reasons, it is not allowed to replace
the lter unit if damp or damaged.
9
Install the dust container with a lter unit on the handheld
cleaner until it clicks into place.
CLEANING THE ELECTROBRUSH
During use, the brushroll may gather pieces of thread,
strings, hair, fabrics, etc. which may affect the efciency of
vacuuming. It is therefore necessary to it at regular intervals.
To remove the dirt from the brushroll, proceed as below:
1
Press electrobrush release button to detach the brush
from the upright frame.
2
Using a screwdriver or a at, narrow object (e.g. a coin),
rotate the locking button on the cover from closed position
„ ” to open position „ ”. Take off the cover and pull out
the roller.
3
Carefully clean the brushroll using scissors or a sharp
knife. Move scissors or a blade along brushroll in such a way
as to catch the hair and threads tangled around it, then cut
and remove the debris.
Be careful not to damage electrobrush bristle
and brushroll.
4
After cleaning, assemble the brushroll back into place.
Pay special attention to t it properly into the openings on the
electrobrush. Press the other end of the brushroll down to
the body of the electrobrush.
Replace the cover. Turn the cover lock to „
●
”.
STORAGE
1
It is recommended to place and store the accessories for
the appliance on the special rack at the base of the charging
station.
2
It is best to store the appliance in a vertical position on
the charging station. To save space, the appliance may be
stored with folded handle.
Where necessary, wipe the cover and dust container
●
with damp cloth (or damp cloth with mild detergent), then
allow to dry or wipe dry with a cloth.
F
G
… 37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer Cito VC1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer Cito VC1200 in the language / languages: English, Polish as an attachment in your email.

The manual is 3,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info