478469
105
Zoom out
Zoom in
Previous page
1/116
Next page
103FTM-10R OPERATING MANUAL
Connector
Connect Wires
6. Attach the “MEK-M10” to the Front
Panel using the previously removed
two screws.
Note: When securing the MEK-M10 to
the front panel, make sure that the rub-
ber gasket is free of any contaminants
and properly seated before securing the
MEK-M10 with the screws. This will
insure that moisture or water does not
enter the front panel.
INSTALLATION OF OPTIONAL ACCESSORIES
7. Attach the Flat cable to the connector
on the Printed Circuit Board, and con-
nect the Wire from the “MEK-M10” to
the Wire from the Printed Circuit Board
in the front panel.
Note: Please adjust the terminal side of
the flat cable to the lower side of the
connector on the Printed Circuit Board,
and insert it in the connector.
MICROPHONE JACK “MEK-M10”
8. Replace the Rear Case, Sub Panel, and
8-pin modular plug.
9. Attach the Front Panel to the Trans-
ceiver Body using the previously re-
moved four screws.
105


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FTM-10R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FTM-10R in the language / languages: English as an attachment in your email.

The manual is 5,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info