478499
98
Zoom out
Zoom in
Previous page
1/132
Next page
96 FT-857D Operating Manual
No Menu Item
059 MIC SEL
060 MTR ARX SEL
061 MTR ATX SEL
062 MTR PEAK HOLD
063 NB LEVEL
064 OP FILTER 1
065 PG A
066 PG B
067 PG C
068 PG ACC
069 PG P1
070 PG P2
071 PKT 1200
072 PKT 9600
073 PKT RATE
074 PROC LEVEL
075 RF POWER SET
076 RPT SHIFT
077 SCAN MODE
078 SCAN RESUME
079 SPLIT TONE
080 SQL/RF GAIN
081 SSB MIC GAIN
082 SSB STEP
083 TONE FREQ
084 TOT TIME
085 TUNER/ATAS
086 TX IF FILTER
087 VOX DELAY
088 VOX GAIN
089 XVTR A FREQ
090 XVTR B FREQ
091 XVTR SEL
Function
The choice of the equipment which connects to the
MIC jack.
Select the analog meter display configuration while
the transceiver is receiving.
Selects the analog meter display configuration
while the transceiver is transmitting.
Enabling/disabling of the “peak hold” function of the
meter.
Setting of the blanking level for the IF Noise
Blanker.
Not available at this time.
Programming the
[
A
]
key (in the Operating
Function Row “q” (MFq)) function.
Programming the
[
B
]
key (in the Operating
Function Row “q” (MFq)) function.
Programming the
[
C
]
key (in the Operating
Function Row “q” (MFq)) function.
Programming the optional MH-59
A8J microphone’s
[
ACC
]
button assignment.
Programming the optional MH-59
A8J microphone’s
[
P1
]
button assignment.
Programming the optional MH-59
A8J microphone’s
[
P2
]
button assignment.
Adjusts the audio input level from the TNC during
1200 bps Packet operation.
Adjusts the audio input level from the TNC during
9600 bps Packet operation.
Sets the transceiver’s circuitry for the Packet baud
rate to be used.
Sets the compression level for the AF speech
processor in the SSB/AM modes.
Setting of the maximum power level for the current
band.
Sets the magnitude of the repeater shift.
Selects the desired Scan-Resume mode.
Sets the delay time for scanning resumption.
Enables/disables split CTCSS/DCS cording.
Selects the configuration of the front panel’s SQL/
RF knob.
Adjusts the microphone gain level for the SSB
mode.
Selects the tuning steps for the SELECT knob on
the SSB mode.
Setting of the CTCSS Tone Frequency.
Select the Time-Out Timer time.
Selects the device (FC-30 or ATAS-100/-120) to be
controlled via the front panel’s
[
A
](
TUNE
)
key.
Selects the Transmit IF filter.
Sets the “hang time” for the VOX circuitry.
Sets the gain of the VOX circuitry’s input audio
detector.
Allows an arbitrary frequency to be set on the
display, to allow direct frequency readout during
transverter operation.
Enables/disables/selects the antenna port to be
used for Transverter operation.
Available Values
NOR/RMT/CAT
SIG, CTR, VLT, N/A, FS,
OFF
PWR, ALC, MOD, SWR,
VLT, N/A, OFF
ON/OFF
0 ~ 100
All Multi Function,
All Menu Item, MONI,
Q.SPL, TCALL, ATC and
USER.
0 ~ 100
0 ~ 100
1200/9600 (bps)
0 ~ 100
5 ~ 100
2 ~ 100 (UHF)
0.00 ~ 99.99 (MHz)
TIME/BUSY/STOP
1 ~ 10 (sec)
ON/OFF
RF-GAIN/SQL
0 ~ 100
1kHz/2.5kHz/5kHz
50 Standard CTCSS tones
OFF/1 ~ 20 (min)
OFF/ATAS(HF)/
ATAS(HF&50)/ATAS(ALL)/
TUNER
CFIL/FIL1/FIL2
100 ~ 3000 (ms)
1 ~ 100
0,000,00 ~ 9999,999,00
(kHz)
OFF/X VTR A/X VTR B
Default
NOR
SIG
PWR
ON
50
MONI
Q. SPL
ATC
MONI
Q. SPL
TCALL
50
50
1200 bps
50
2
2
TIME
5 sec
OFF
1
50
2.5kHz
88.5 Hz
OFF
OFF
CFIL
500 ms
50
OFF
MENU OPERATION
1: Depends on transceiver version.
2: Depends on operating band and transceiver version.
98


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-857D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-857D in the language / languages: English as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info