684723
21
Zoom out
Zoom in
Previous page
1/22
Next page
11
EN
Status LED Disconnect voltage
12vdc system 24Vdc system
Mode 1
Green
(factory setting)
12,5Volt 25,0Volt
Mode 2 Green, flashing 12,0Volt 24,0Volt
Mode 3 Orange 11,5Volt 23,0Volt
Mode 4 Orange, flashing 11,0Volt 22,0Volt
Mode 5 Red 10,5Volt 21,0Volt
Mode 6 Red, flashing 10,0Volt 20,0Volt
If the mode button has not been used for 10 seconds, the protector
leave the set-up process. The last selected setting will remain in the
memory even if the device has been disconnected from the input.
IN USE
Important
Check the cables and connections regularly. Keep the connections
clean and replace damaged cables immediately.
When connected to the battery (input) the set value will be displayed for
10 seconds. After this, depending on the measured voltage, the
protector will leave the output switched off (<13.0/26.0 Volts) or
enable it (>13.0/26.0 Volts). If required, switch the protector on
manually if the battery is below switching level, see paragraph 'manual
re-start'.
As long as the measured input voltage is above the set value, the
connected consumers will be supplied with power. As soon as the
measurement has reached the set value, the protector will intervene
and stop the power supply. So, bear in mind that at that point, the
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xenteq SBP-SERIES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xenteq SBP-SERIES in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info