Zoom out
Zoom in
Previous page
1/13
Next page
1
1


Need help? Post your question in this forum.

Forumrules


Content of pages


  • Page 1

    1 ...
  • Page 2

    CONTENTS QUICK REFERENCE GUIDE PLEASE READ INSTRUCTIONS FOR USE BOOKLET! PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET 2 BEFORE USING THE DRYER Page 3 PRECAUTIONS AND GENERAL RECOMMENDATIONS Page 5 ELECTRICAL CONNECTION Page 7 DESCRIPTION OF THE DRYER Page 8 REMINDER - MAINTENANCE AND CLEANING Page 8 CLEANING THE LINT FILTER Page 8 CLEANING THE HEAT EXCHANGER Page 9 DRAINAGE SYSTEM Page 10 DOOR REVERSIBILITY Page 11 TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE Page 12 ...
  • Page 3

    BEFORE USING THE DRYER • This dryer is exclusively designed to dry machine dryable laundry in quantities which are usual for private households. • Observe the instructions given in these Instructions For Use and the Programme Chart before using the dryer. • Keep the Instructions For Use and the Programme Chart handy for reference. If you pass on the dryer to others, make sure that the Instructions For Use and the Programme Chart go with it. • The manufacturer declines all liability for damage to property or injury to persons or animals due to noncompliance with the directions given in these Instructions For Use. 1. Removing the packaging and inspection • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use it. Contact the After-Sales Service or your local retailer. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. • Do not operate the dryer if it has been damaged du ...
  • Page 4

    • The dryer is not designed for built-in installation. • The dryer can be installed under a worktop, provided that adequate ventilation of the dryer is assured. Install a ventilation grid (minimum 45 cm x 8 cm), in the rear part of the worktop under which the dryer is installed. D. Secure both distance holders by turning them in a clockwise direction as far as the stop position. D 4. Assembly of distance holders To ensure that the appliance is positioned at a correct distance from the wall at the rear side and to allow sufficient ventilation, distance holders must be mounted on the rear side of the dryer before starting the first drying cycle. A. Remove the two distance holders from the packaging. B. The distance holders must be inserted on the rear side of the dryer in the protective cover. 5. User and child protection • Children must not be allowed to play with the dryer. • Ensure that children and small animals cannot get into the drum. • Keep the packa ...
  • Page 5

    PRECAUTIONS AND GENERAL RECOMMENDATIONS To minimise the risk of fire in the tumble dryer, the following precautions should be observed: • Oil-soaked items ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the item can become hot enough to catch fire. Piling, stacking or storing oil-soaked items can prevent heat from escaping and so create a fire hazard. • Do not dry unwashed items in the tumble dryer. • Ensure that the appliance is maintained as shown in the section “Maintenance and cleaning”. • Ensure that the appliance is installed as per the instructions above. • Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers must be washed in hot water with an extra amount of detergent before being dried in the tumble dryer ...
  • Page 6

    Packaging • The packaging box is 100% recyclable, as confirmed by the recycling symbol. Disposing of packaging and old appliances • The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before scrapping cut off the power cable so that the dryer cannot be connected to the mains. on the product or on the • The symbol documents accompanying the product indicates that this appliance must not be treated as household waste. Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. • For more detailed information about treatment, recovery and recycling of this product please contact your local city council office, your household waste disposal service or the shop where you purchased the product. Energy saving tips • Always dry a ...
  • Page 7

    ELECTRICAL CONNECTION 1) For United Kingdom only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an ASTA marked fuse, approved to BS 1362 and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. Important: The fuse cover must be refitted when changing a fuse. If the fuse cover is lost, the plug must not be used until a correct replacement is fitted. Correct replacements are identified by the colour insert or by the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of United Kingdom will frequently apply, but a third type of plug and socket is also used, the 2-pin type with side earth terminal. 3) Socket outlet / plu ...
  • Page 8

    DESCRIPTION OF THE DRYER A. Work top B. Water container C. Contact pin D. Door: To open the door, pull the handle. To close the door, push gently until closed. E. Filter F. Heat exchanger G. Heat exchanger flap REMINDER - MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, switch off the dryer. AFTER EACH DRYING CYCLE • Clean the lint filter at the end of every drying cycle. • Empty the water container at the end of each drying cycle. EACH MONTH • Clean the heat exchanger at least every month (see “Cleaning the heat exchanger” on the next page). CLEANING THE LINT FILTER Depending on the model of your dryer, the lint filter can have different shapes. Clean the lint filter after every drying cycle, or when the lint filter indicator lamp lights up, proceeding as follows: A. Take the lint filter out of the dryer and carefully open the filter. B. Carefully remove the complete lint from the lint screen. A A B B When the lint f ...
  • Page 9

    CLEANING THE HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every month, or whenever the heat exchanger indicator lamp lights up (optional feature, depending on the model of your dryer), proceeding as follows. A. Open the heat exchanger flap and put it to one side. A B. Turn the two locking bars at the side of the heat exchanger towards the middle, to the horizontal position, and pull the heat exchanger out. B C. Hold the heat exchanger as shown in the picture. Clean it under running water by turning it around to reach all sides, especially in front and behind. Wipe away dust and lint from the heat exchanger seals and plates. Clean the inside of the heat exchanger plates under running water, from the front side to the back. C D. Remove the lint from the heat exchanger housing by hand or with a damp cloth. Clean the entire housing from the back to the front side, ensuring that all lint is removed ...
  • Page 10

    DRAINAGE SYSTEM For your convenience: The dryer can be connected directly to the sewage system of the house to avoid having to empty the water container after each drying cycle. C. Connect the hose to the sewage system. The height difference between the floor where the dryer is positioned and the sewage system connection should not exceed 1 m. Place an absorbent cloth underneath to collect water spillage. A. Unplug the hose located at the upper rear part of the dryer. C Notice: To prevent water siphoning back into the appliance, the end of the hose must not be immersed in the drain water. Avoid bending and twisting the hose. A B. Remove the hose from the rear protective cover. B 10 ...
  • Page 11

    DOOR REVERSIBILITY For your convenience: In case you want to stack the dryer on a washing machine, you can reverse the door opening direction, to lower the position of the door handle. Unplug the dryer. A A. Open the door. B. Using a spanner, turn the contact pin (B) in the top part of the door through 90° and pull it out. B C. Remove the door lock: Unscrew the 2 screws above and below the door lock system. C D. Press the small knob above the door lock system with a small screwdriver, move the door lock slightly upwards and pull the door lock towards you with your finger. D E. Reverse the door: Remove the two screws of the door fixing plate. Fasten the door again on the desired side with the 2 screws. Take care to tighten the screws horizontally to avoid pinching off the door seal. Reposition the door lock: Insert the door lock on the opposite side of the door fixing plate. Press it fully into the hole and move it downward slightly, until the sma ...
  • Page 12

    TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE In the event that the dryer malfunctions, one of the following failure codes may be displayed. Depending on the model of your dryer, the failure may be displayed in letters or by different blinking LEDs. Failure code LED failure code Check to be carried out by customer before service call F01 Please call the After-Sales Service. F02 Please call the After-Sales Service. F03 Please call the After-Sales Service. F04 Please call the After-Sales Service. F05 Turn the dryer OFF and unplug it. Make sure that the ambient temperature is between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the failure reoccurs, please call the After-Sales Service. F06 Turn the dryer OFF and unplug it. Make sure that the ambient temperature is between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the failure reoccurs, please call the After-Sales Service. F07 Pl ...
  • Page 13

    TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE If a fault occurs, before contacting our AfterSales Service, perform the following checks to try to remedy the problem: Drying takes too long / laundry is not dry enough: • Correct programme selected? • Laundry too wet (Washing machine spin speed less than 1000 rpm? When the spin speed is less than 1000 rpm a water container fault may occur during the drying cycle). • Lint filter clogged (filter indicator lamp on?) • Heat exchanger clogged? (refer to the sections “CLEANING THE LINT FILTER/CLEANING THE HEAT EXCHANGER”). • Is the ambient temperature too high? • END indicator lamps on? The drying cycle is complete and the laundry can be taken out. • ‘Gentle’ option selected? The ‘Gentle’ option should only be selected with small loads. • Mixed laundry load (for example cotton and synthetics). After-Sales Service If, after carrying out the above checks, the malfunction persists or reoccurs, turn the dryer off and call th ...



Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AWB 721 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AWB 721 in the language / languages: English as an attachment in your email.

The manual is 2,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AWB 721

Whirlpool AWB 721 Quick start guide - English - 5 pages

Whirlpool AWB 721 User Manual - German - 12 pages

Whirlpool AWB 721 Quick start guide - German - 5 pages

Whirlpool AWB 721 User Manual - Dutch - 11 pages

Whirlpool AWB 721 Quick start guide - Dutch - 5 pages

Whirlpool AWB 721 User Manual - French - 11 pages

Whirlpool AWB 721 Quick start guide - French - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info