805502
2
Zoom out
Zoom in
Previous page
1/2
Next page
BEDIENUNGSANLEITUNG
D
FUNK-INITIALISERUNG (Funk-Paarung)
Einzel Funk-Empfängereinheit 230Vac (EFHRFR 001)
TECHNISCHE DATEN
BETRIEBSARTEN
- Funk-Empfängereinheit (868 MHz)
- Eigene, unverwechselbare Verschlüsselung bei jedem Produkt
-Mit Mode Taste für AUTO, HAND- oder FUNK-
INITIALISIERUNGSMODUS
-Einsatz nur in Verbindung mit einem Funk-Thermostaten dieser
Baureihe
LED ANZEIGE
Handbetrieb LED.
(Gelb)
Heizen LED.
(Rot)
Funk LED.
(Grün)
Gelb Rot Grün
0 0 0 Automatisch, Heizung inaktiv
0 1 0 Automatisch, Heizung aktiv
1 0 0
Manuell, Heizung inaktiv
1 1 0 Manuell, Heizung aktiv
0 oder
1
0 oder
1 schnell blinkend Erhalten einer Anforderung.
0 oder
1
0 oder
1 1 Warten auf Konfigurationssignal (siehe
Konfiguration)
0 0 langsam blinkend FEHLER siehe Reparaturanleitung unten:
Reparaturanleitung
- Batterien des Empfängers prüfen
- Reichweite von Sender und Empfänger
prüfen
- Störungen durch Geräte in weniger als 50 cm
Entfernung vom Empfänger?
- Störung durch Geräte auf der Frequenz 868
MHz (dauerhafte Übertragung)?
Keine Reaktion nach Drücken des
Hand-Knopfs
- Korrekten Anschluss des Empfängers prüfen
- Netzspannung von 230 V/AC prüfen
Betriebstemperatur 0°C - 50°C (32°F – 122°F)
Schutzart Schutzklasse II - IP 44
Betriebsspannung 230Vac 50Hz
Funk Frequenz und
Empfangsbereich
868 MHz, <10mW.
Funk-Reichweite offene Distanz: ca. 100 m.
Funk-Reichweite in Gebäuden: ca. 30 m
Zulassungen CE. EN 300220-1, EN 301489-1
(Radio frequency certifications)
Schaltleistung Relais 12A 250Vac
Mode Taste
AUTO Mode
Handbetrieb
(Heizen)
Manual Mode
(Stop Modus)
Taste 4 sec.
drücken
Taste drücken
Taste drücken
Taste drücken RF init
Taste drücken
1. Versorgen Sie den Funk-Empfänger mit Netzspannung. Drücken Sie die Mode Taste
für ca. 4 Sek. Die grüne LED sollte aufleuchten. Der Empfänger befindet sich nun im
Funk-Initialisierungsmodus und ist für bereit für die Paarung mit dem Funk-Thermostat.
2. Bitte beachten Sie die Bedienungsanleitung des Funk-Thermostaten und bringen Sie
diesen in den Modus Funk-Konfiguration (Funk-Paarung).
3. Stellen Sie sicher, dass der Funk-Empfänger das Funk-Signal korrekt erhalten hat. Am
Empfänger sollte die grüne LED beim Empfang eines Funk-Signals blinken.
4. Verlassen Sie die Funk-Konfiguration am Thermostaten. (Bitte die entsprechende
Bedienungsanleitung beachten).
5. Betreiben Sie die Anlage im Autobetrieb
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Watts EHRFR One zone receiver at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Watts EHRFR One zone receiver in the language / languages: English as an attachment in your email.

The manual is 0.21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info