805502

Watts EHRFR One zone receiver Manual

1
Zoom out
Zoom in
Previous page
1/2
Next page
USER GUIDE GB
1 channel RF Receiver 230Vac (EFHRFR 001)
TECHNICAL CHARACTERISTICS
MODES DESCRIPTION
- Radio frequency RF receiver (868 Mhz).
- Personal code on each product.
- Equipped with a push button to select AUTO, MANUAL or RF INIT
mode.
- To be used only with ours thermostats.
LED INDICATOR
PPL IMP 2362A
RADIO CONFIGURATION MODE
1. Install and plug the Receiver. Then press the Receiver push button during 4
seconds, the Green LED should lit up indicating that the Receiver is now in radio
configuration mode waiting for a thermostat configuration address.
2. Please refer to the thermostat leaflet for enter the thermostat in “RF Init” mode.
3. Verify that radio signals are correctly received by the Receiver. On the Receiver,
the Green LED should blink at each radio signal received from the thermostat.
4. Exit the Radio configuration mode on the thermostat. (Please refer to the
thermostat leaflet)
5. Now starting up your installation in AUTO mode..
Yellow Red Green
0 0 0
Automatic mode, HEATER stopped
0 1 0 Automatic mode, HEATER operating
1 0 0
Manual mode OFF forced
1 1 0 Manuel mode HEATER forced
0 or 1 0 or 1 quick flash Reception of an order, 4 flash
0 or 1 0 or 1 1 Waiting for a configuration signal (cf. configuration)
0 0 slow blink ERROR see repair sequence bellow:
Repair instructions
- Verify the emitter batteries.
- Verify the emitter/receiver range.
- No perturbation by an apparatus at less than 50cm of
the receiver.
- No perturbation by an apparatus on the 868 MHz
frequency (continuous transmission).
By pressing on the push
button
nothing happens
- Verify that the receiver is correctly connected
- Verify main power supply (230VAC)
Manual Mode LED.
(Yellow)
Heating LED.
(Red)
RF LED.
(Green)
Mode push button
AUTO Mode
Manual Mode
(Heater forced)
Manual Mode
(Stop forced)
Press button
during 4sec
Press button
Press button
Press button RF init
Press button
Operating temperature 0°C - 50°C (32°F – 122°F)
Electrical
Protection Class II - IP44
Power Supply 230Vac 50Hz
Radio frequency and
Receiving zone
868 MHz, <10mW.
Range of approximately 100m in open space.
Range of approximately 30m in residential environment.
certifications CE. EN 300220-1, EN 301489-1
(Radio frequency certifications)
Output Relay 12A 250Vac
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Watts EHRFR One zone receiver at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Watts EHRFR One zone receiver in the language / languages: English as an attachment in your email.

The manual is 0.21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info