652064
4
Zoom out
Zoom in
Previous page
1/8
Next page
4
Fig. 3Abb. 3 Fig. 4
90°
15 mm
15 mm
Ø 6 mm
Abb. 4
Fig. 2
Abb. 2
Sh0 (Rangierverbot)
Sh0 (shunting prohibited)
Sh1 (Rangierverbot aufgehoben)
Sh1 (shunting allowed)
blaues Kabel mit roter Markierung
blue cable with red marking
blaues Kabel mit grüner Markierung
blue cable with green marking
5. Montage
1) Prüfen Sie vor dem Einbau des Signals, wie im
Punkt „Funktionskontrolle“ beschrieben, des-
sen einwandfreie Funktion.
2) Beschriften Sie das Signal gemäß den Hinwei-
sen auf Seite 3.
3) Sägen Sie an der Montagestelle ein Loch mit
den Maßen 15 mm x 15 mm. Bohren Sie dazu
zuerst 4 Löcher mit 6 mm Durchmesser. Ver-
wenden Sie die in der Abbildung 3 abgedruckte
Schablone.
4) Führen Sie die Anschlusskabel von oben durch
das Montageloch und stecken Sie dann das Si-
gnal mit dem Antrieb voran hinein.
5) Halten Sie die Bodenplatte des Signals jetzt
von oben fest. Schieben Sie den Befestigungs-
ring von unten so auf den Antrieb, dass die
Rastnasen um 90° zu der Riffelung am Gehäu-
se des Antriebes verdreht sind. Wenn nun die 4
Kunststofaschen des Befestigungsringes mit
der Anlagenplatte unter mechanischer Span-
nung stehen, drehen Sie den Ring so, dass die
Nasen in der Riffelung des Antriebsgehäuses
für einen festen Halt sorgen.
5. Mounting
1) Check that the signal works properly as per the
instructions above before you start installing it
on the layout.
2) Letter the signal in accordance with the instruc-
tions on page 3.
3) Saw a square hole of 15 mm x 15 mm at the
mounting place. But before 4 holes of 6 mm di-
ameter each should be drilled in the corners.
Please use the pattern which is shown in gure
3.
4) The signal‘s connection wires have to be insert-
ed into the hole rst. After that put the signal
with the drive rst into that hole.
5) Now the base plate of the signal has to be held
in place (perhaps by a second person). Then
push the mounting ring from below onto the
drive in such a manner that the tabs are at a
right angle to the groves on the housing of the
drive. Once the 4 plastic tabs of the mounting
ring are under tension, you turn the ring until
the tabs lock against the groves on the hous-
ing.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viessmann 4515 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viessmann 4515 in the language / languages: English, German as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info