Manual Trek Incite 8i - 2005 (page 4 of 10) (English)

775418

Zoom out

Zoom in

1/10

Attaching the computer wire

The computer wire is usually longer than needed. Extra wire length can be

diverted by wrapping it around the brake housing prior to routing it down the fork

blade or down tube (Figure 9).

Make sure the computer wire is not pulled tight when the handlebar is turned all

the way to either side.

Wireless computers do not have wires. For wireless computers, see

To install the

sensor.

To attach the computer wire

1. Determine the length of wire to divert by holding the sensor at its desired

mounting point.

2. Wrap the wire around the front brake cable, diverting the determined amount.

3. Continue routing the wire, either by wrapping around the fork or frame tube, or

attach the wire to the fork or frame tube with electrical tape.

4. As needed, solidify the wire attachment with either nylon ties or electrical tape.

To install the sensor

These instructions are written for the front wheel, but apply equally to installing

the magnet and cadence sensor which go on the left crank and the frame’s

chainstay.

1. Align the sensor with the magnet.

The magnet must pass across the line on the sensor (Figure 10).

2. Orient the sensor so that the clearance between the sensor and the magnet is

between 1 to 3mm.

The sensor can be rotated around the fork blade or crank about 45 degrees.

If needed, the sensor and magnet can be moved up or down the fork and wheel to change the

clearance.

3. For the wireless sensor, install the rubber “foot” in the sensor (Figure 11).

4. Attach the sensor with nylon ties, but do not fully tighten.

5. With the computer in the computer base, check the alignment of the sensor and

magnet by spinning the wheel and noting if the computer is displaying speed.

If the computer shows current speed, the sensor is reading the magnet. If the computer is not

displaying current speed, realign the sensor and magnet until current speed is displayed.

6. Tighten the nylon ties and trim the excess length (Figure 12).

Installation

Figure 12- Trim excess

nylon tie length

Figure 11- Wireless sen-

sor, foot, and fork blade

Figure 8- Magnet placed

on crankarm, aligned

with sensor on chainstay

Figure 9- Extra wire

wrapped around the

brake housing

Figure 10- Magnet align-

ment and clearance

1.0 -

3.0mm

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Trek Incite 8i - 2005 in the language / languages: English as an attachment in your email.

The manual is 0.4 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Trek Incite 8i - 2005 Manual

Product: