636738
21
Zoom out
Zoom in
Previous page
1/23
Next page
www.texas.dk
21
7. Chain brake
Test the chain brake in the following way.
1. Place the saw on a solid foundation.
2. Start the engine.
3. Keep right hand on the rear handle.
4. Keep left hand on the front handle.
5. Start the engine and activate the chain brake be pulling the chain brake forward.
6. The chain must stop instantly. When it stops, release the throttle control.
7. If the chain brake works, stop the engine and release the chain brake by pushing it
forward in deactivated position.
8. Adjustment of chain with no use of tools
Loosen the shield nut and turn the yellow ring
clockwise to tighten and anti-clockwise to
loosen the chain.
Fasten the shield nut afterwards.
9. Maintenance
Lubrication hole. Dismount bar and control if the
lubrication hole (1) is blocked with sawdust or dirt..
Bar. Clean the nose wheel and running path for
dirt. Turn if necessary the bar in order to spread
the wear. A worn bar can be dangerous to use
and should be replaced.
Chain. The chain should be filed on a regular
basis in order to spread the wear and to reduce
wear on the electric engine.
1. Make sure the bar is tightened properly.
2. Use a 4 mm file
3. File all teeth from the inside as shown
on the drawing.
4. It is necessary to inspect the height of
the teeth on a regular basis. If they are
too high, they should be filed.
If in doubt, contact your local Texas dealer.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas EK 2040 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas EK 2040 in the language / languages: English, Danish, Swedish as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info