636738
20
Zoom out
Zoom in
Previous page
1/23
Next page
www.texas.dk
20
5. Chain oil
Use always chain oil for lubrication of bar and chain. Ordinary engine oil is not
recommendable. Texas recommends Klingtex chain oil viscosity 125.
A container with 100 ml chain oil is included. Remove the oil cover (1) and pour in the oil.
Check the oil level in the oil indicator (4) on the right side of the saw every 15 minutes. The
oil level must never be below the indication of minimum as there is a risk that the chain will
not be lubricated properly and the chain may be damaged..
For further lubrication of the chain use the lubrication hole (5) on the tip of the bar. Use a
syringe to put oil into the hole. Pull the chain at the same time.
Always make sure the power is disconnected and the chain brake (2) is deactivated.
The cord holder (3) is used to lessen the pull on the electric cord on the saw.
6. Start / stop
1. The saw is started by activation the throttle control.
2. The switch on the left side of the handle must
be pressed, before the saw is started.
3. The saw is stopped be releasing the throttle control.
4. Chain brake handle must always be withdrawn during
use
Start
4
3
2
1
5
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Texas EK 2040 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Texas EK 2040 in the language / languages: English, Danish, Swedish as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info