Manual Telwin STARTRONIC 530 (page 2 of 92) (All languages)

627245

Zoom out

Zoom in

1/92

constant voltage and current that is electronically controlled

_____________( GB )______________

by means of a microcontroller.

They can be used to charge free electrolyte lead-acid (WET)

INSTRUCTION MANUAL

batteries and sealed (GEL/AGM) batteries on motor

vehicles (petrol and diesel), motor-cycles and boats.

Rechargeable batteries according to the output voltage

available: 6V / 3 cells; 12V / 6 cells; 24V / 12 cells.

- It is installed in a container with an IP20 protection rating

WARNING: BEFORE USING THE BATTERY CHARGER

and is protected against indirect contact by means of an

READ THE INSTRUCTION MANUAL CAREFULLY.

earth conductor, as required for class I appliances.

1. GENERAL SAFETY RULES WHEN USING THIS

3. TECHNICAL INFORMATION

BATTERY CHARGER

ST330 ST530

Power supply: 230V-1ph 230V-1ph

Absorbed current: max. charging: 8A 10A

max. start: 30A 50A

- During the charge the battery produces explosive gases,

Charge voltage: 6-12-24V 6-12-24V

avoid the formation of flames and sparkes. DO NOT

Charge@90% power supply voltage: 30A 40A

SMOKE.

- Position the batteries to be charged in a well-ventilated

Start: @12V (1V/c): 200A 300A

place.

@24V (1V/c): 200A 300A

External safeguards: 16A-T 16A-T

1A-T 1A-T

Stand-by: voltage 12V 12V

- Inexperience and untrained people should be

current 1,5A 1,5A

properly instructed before using the appliance.

- People (children included) whose physical, sensory

4. DESCRIPTION OF THE BATTERY CHARGER

or mental capacities would prevent them from using

FIG. A

the appliance correctly must be supervised by a

1-Selecting the Type of Battery:

person who is responsible for their safety while the

It is possible to select the type of battery to be charged.

appliance is in use.

Making the selection automatically modifies the battery

- Children must be supervised to ensure that they do

voltage threshold.

not play with the appliance.

The following types of battery can be selected:

- Use the battery charger only indoors and make sure that

"GEL/AGM": lead-acid battery with solid electrolyte.

you start it in airy places. DO NOT SET IN THE RAIN OR

"WET": lead-acid battery with liquid electrolyte.

SNOW.

2-Selecting the Battery Voltage:

- Disconnect the mains cable before connecting to or

This key is used to select the voltage of the battery/ies.

disconnecting the charging cables from the battery.

The available working voltages are the following:

- Do not connect or disconnect the clamps to or from the

“6V”:3 elements;

battery with the battery charger operating.

“12V”:6 elements;

- Never use the battery charger inside the car or in the

“24 V”:12 elements.

bonnet.

3-Selecting Operating Mode:

- Substitute the mains cable only with an original one.

TEST: charging off.

- Do not use the battery charger to charge batteries which

In this mode it is possible to:

are not rechargeable.

- Check the actual voltage and condition of the battery.

- Make sure the available power supply voltage

- Insert the setting for the battery voltage and type.

corresponds to that shown on the battery charger rating

- If there is an error in the connection or the setting the

plate.

display will flash the message “Err” until the problem has

- To avoid damaging the vehicle's electronics, read, keep

been solved.

and take very careful note of the information supplied by

CHARGE: In this mode the battery or batteries can be

the vehicle manufacturer, when using the battery charger

charged at constant current depending on the setting and

either for charging or starting; the same applies to the

in any case in relation to the battery capacity (Ah).

instructions supplied by the battery manufacturer.

When the battery has reached a set voltage level at the

- This battery charger has components such as switches

end of charging this will be maintained for the remaining

and relays which can cause arcs or sparks. Therefore

time.

when using it in a garage or in a similar place set the

Moreover, if the battery voltage is particularly low the

battery charger in a suitable case.

charger limits the charge current until the battery reaches

- Repair or maintenance of the inside of the battery charger

the safety voltage of 1.5 volts per element. Under these

can be executed only by skilled technicians.

operating conditions the display shows the fixed current

- WARNING: ALWAYS DISCONNECT THE POWER

value alternating with “LCC” (Limit Charging Current).

SUPPLY CABLE FROM THE MAINS BEFORE

NOTE: The user can exclude this protection (for details

CARRYING OUT ANY SIMPLE MAINTENANCE

see the section on SAFEGUARDS).

OPERATION ON THE BATTERY CHARGER.

TRONIC: Automatic charging enabled.

- Make sure the power outlet is protected by an earth

In this mode the battery or batteries are charged

connection.

automatically in the same way as previously but with

- For those models without one, connect a plug with

preset voltage thresholds.

suitable capacity in relation to the fuse size shown on the

START: The START function is used to start the engine in

data plate.

cycles lasting ”4 sec ON” and ”40 sec OFF”.

- MAKE SURE THE BATTERY CHARGER IS IN THE “OFF”

4-STAND-BY:

P O S I T I O N B E F O R E C O N N E C T I N G O R

The STAND-BY function gives a stabilised output power

DISCONNECTING THE CLAMPS TO THE BATTERY

supply of 12VDC-1.5A. When the plug of the STANDBY

TERMINALS.

connector is inserted into the cigar-lighter outlet the

corresponding LED lights up automatically.

2. INTRODUCTION AND GENERAL DESCRIPTION

This function can also be activated simultaneously with

The models described here are battery chargers/starters

battery charging, by enabling the “CHARGE” function.

5-Battery charge status indicator:

- 2 -

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Telwin STARTRONIC 530 in the language / languages: All languages as an attachment in your email.

The manual is 1,77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Telwin STARTRONIC 530 Manual

Product: