Manual Telwin ALASKA 150 START (page 4 of 72) (All languages)

627229

Zoom out

Zoom in

1/72

- 4 -

1.GENERALSAFETYRULESFORTHEUSE

- During the charge the battery produces explosive gases,

avoid the formation of ames and sparkes. DO NOT

SMOKE.

- Position the batteries to be charged in a well-ventilated

place.

- Inexperience and untrained people should be

properlyinstructedbeforeusingtheappliance.

- People (children included)whose physical, sensory

or mental capacities would prevent them from using the

appliancecorrectly mustbe supervisedby aperson who is

responsiblefortheirsafetywhiletheapplianceisinuse.

- Childrenmustbesupervisedtoensurethattheydonotplay

withtheappliance.

- Use the battery charger only indoors and make sure that you start

it in airy places. DO NOT SET IN THE RAIN OR SNOW.

- Disconnect the mains cable before connecting to or disconnecting

the charging cables from the battery.

- Do not connect or disconnect the clamps to or from the battery with

the battery charger operating.

- Never use the battery charger inside the car or in the bonnet.

- Substitute the mains cable only with an original one.

- Do not use the battery charger to charge batteries which are not

rechargeable.

- Make sure the available power supply voltage corresponds to that

shown on the battery charger rating plate.

- To prevent damaging the vehicle electronics, scrupulously respect

the warnings given by the producer of the vehicle or the batteries

used.

- This battery charger has components such as switches and relays

which can cause arcs or sparks. Therefore when using it in a

garage or in a similar place set the battery charger in a suitable

case.

- Repair or maintenance of the inside of the battery charger can be

executed only by skilled technicians.

- WARNING: ALWAYS DISCONNECT THE POWER SUPPLY

CABLE FROM THE MAINS BEFORE CARRYING OUT ANY

SIMPLE MAINTENANCE OPERATION ON THE BATTERY

CHARGER.

- The battery charger is protected from indirect contact by an earth

wire as indicated for class I equipment. Make sure the power outlet

is protected by an earth connection.

- For models supplied without plugs, connect plugs having a

capacitance suitable for the value of the fuse shown in the plate;

for models supplied with cable and plug and with a ”P.MAX

START” power higher than 9kW, when used for starting, we advise

replacing the plug with one having a capacitance suitable for the

fuse shown in the plate.

2.GENERALDESCRIPTION

2.1AUTOMATICBATTERYCHARGERS(TRONIC)

Automatic battery chargers (electronic control of the charge process,

interruption and automatic restart) designed for charging sealed

batteries (GEL AGM) in TRONIC mode, and lead electrolyte free

batteries (WET) in manual CHARGE mode, used on motor vehicles

(petrol and diesel), motorcycles, boats etc. It is possible to recharge

12V and 24V batteries.

3.CONTROL,ADJUSTMENTANDINDICATORDEVICES

3.1CHARGELEVELINDICATOR(AMMETERFIG.A)

During the charge phase, the charge level indicator moves from right

to left indicating a decrease in the current required by the battery

as far as near zero levels (battery charged). Please note that the

exact battery status can only be determined using a hydrometer,

that allows you to measure the specic density of the electrolyte. For

battery chargers in manual CHARGE mode, it will be necessary to

monitor the ammeter to determine when the battery is fully charged

and needs to be disconnected from the battery charger to prevent

overheating or damage to the same. In START mode, the indicator

will move to the far right indicating the use of maximum current.

3.2 SETTING THE CHARGE MODE AND CHARGE CURRENT

(FIG.B)

The switch seen in gure B-1 is used to select the TRONIC or

CHARGE mode settings.

The current and charge voltage (where available) is increased by

moving the switch cursor seen in gure B-2 from left to right, within

the CHARGE/TRONIC range.

Move the cursor seen in gure B-2 to the far right to reach the START

position to help start the vehicle.

3.3INDICATORLEDS(FIG.C)

The LED seen in gure C-1 indicates that the charge clamps are

connected to the battery with the poles inverted.

WARNING! Although the battery charger is protected by a resettable

fuse, always avoid creating sparks connecting the clamps with the

poles inverted! Disconnect the clamps immediately and connect

them to the battery correctly.

The two-tone LED seen in gure C-2 is always red in CHARGE mode

and indicates that the battery is charging. In TRONIC mode, the LED

turns green when the charge phase is completed.

4.INSTALLATION

4.1POSITIONINGTHEBATTERYCHARGER

During operation, position the battery charger on a stable surface

and make sure that there is no obstruction to air passage through the

openings provided to ensure sufcient ventilation.

4.2CONNECTIONTOTHEMAINSUPPLY

- The battery charger should be connected only and exclusively

to a power source with the neutral lead connected to earth.

Check that the mains voltage is the same as the voltage of the

equipment.

- Check that the power supply is protected by systems such as

fuses or automatic switches, sufcient to support the maximum

absorption of the equipment.

- The connection to the main supply has to be made using a suitable

cable.

- If you put an extension to the primary cable, the section should

be adequate and, in any case, never less than that of the cable

supplied.

- You always have to earth the equipment with the yellow/green wire

contained in the main cable, indicated by the label (W), while the

other two wires should be connected to the phase and the neutral

cable.

1.GENERALSAFETYRULESFORTHEUSE.............................. 4

2.GENERALDESCRIPTION.......................................................... 4

2.1 AUTOMATIC BATTERY CHARGERS (TRONIC) ................... 4

3.CONTROL,ADJUSTMENTANDINDICATORDEVICES........... 4

3.1 CHARGE LEVEL INDICATOR (AMMETER FIG. A) ............... 4

3.2 SETTING THE CHARGE MODE

AND CHARGE CURRENT (FIG. B) ....................................... 4

3.3 INDICATOR LEDS (FIG. C) ................................................... 4

4.INSTALLATION............................................................................ 4

4.1 POSITIONING THE BATTERY CHARGER ........................... 4

4.2 CONNECTION TO THE MAIN SUPPLY ................................ 4

5.OPERATIONDURINGCHARGING............................................. 5

5.1 BATTERY PREPARATION ..................................................... 5

5.2 BATTERY CHARGER/BATTERY CONNECTION .................. 5

5.3 MANUAL CHARGE AND AUTOMATIC CHARGE MODES ... 5

5.3.1 MANUAL CHARGE (CHARGE) MODE ........................ 5

5.3.2 AUTOMATIC CHARGE (TRONIC) MODE ................... 5

5.4 SIMULTANEOUS CHARGING OF MULTIPLE BATTERIES .. 5

5.5. CHARGE ENDING ................................................................ 5

6.VEHICLESTARTINGOPERATION............................................. 5

6.1 BATTERY CHARGER/BATTERY CONNECTION .................. 5

6.2 STARTING WITH START ....................................................... 5

6.3 END OF STARTING ............................................................... 5

7.BATTERYCHARGERPROTECTION......................................... 5

8.USEFULADVICE......................................................................... 5

INDEX

ENGLISH

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Telwin ALASKA 150 START in the language / languages: All languages as an attachment in your email.

The manual is 1,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Telwin ALASKA 150 START Manual

Product: