612603
4
Zoom out
Zoom in
Previous page
1/6
Next page
RQT5559
4
Notes
Speaker impedance and allowed input
Impedance 8
Input power 100 W (DIN)
The only receivers or amplifiers you should connect to these speak-
ers are those whose rated output does not exceed the above fig-
ures.
Using a receiver or amp with higher ratings than listed above can
cause abnormal sounds to occur because of excessive input, dam-
age to the receiver or speakers, and fire. If equipment is damaged in
any way or unexpected trouble occurs during playback, unplug the
system from its outlet and call a servicenter for assistance.
Protection circuitry
These units incorporate protection circuitry to protect them from dam-
age caused by excessive input or abnormal signals; when excess
input is detected, input is automatically interrupted.
If sound is interrupted...
1.Reduce the volume of the receiver (or amplifier).
2.Check the sound source and connections for any problems.
If there is no problem, the protection circuitry will reset in a few
minutes.
After the protection circuit is reset...
Take care not to increase the receiver’s volume too high.
Excessive input
Be sure to reduce the volume on the receiver (or amplifier) when the
signal input exceeds the rated allowable input to avoid damage to
circuitry or other malfunctions.
Other notes
The speaker nets cannot be removed.
Keep magnetized items away
Magnetized cards, bank cards, commuter passes, etc., can be dam-
aged if allowed too near speaker magnets. Clocks may also be af-
fected.
Avoid locations such as described below.
In direct sunlight
Near heating appliances or other sources of heat
Where the humidity is high
Maintenance
To clean these units, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap-
and-water solution or a weak detergent solution.
Never use alcohol, paint thinner, or benzine to clean these units.
Before using chemically treated cloth, read the instructions that
came with the cloth carefully.
Remarques
Impédance des enceintes et puis-
sance admissible
Impédance 8
Puissance admissible 100 W (DIN)
Seuls les amplificateurs ou récepteurs dont la puissance de sortie
nominale ne dépasse pas celle donnée ci-dessus doivent être
raccordés aux enceintes acoustiques.
L’utilisation d’un amplificateur ou d’un récepteur plus puissant pourrait
non seulement faire exploser les enceintes ou l’ampli lui-même mais
pourrait causer un incendie. Dans l’éventualité d’un mauvais
fonctionnement des appareils ou si ceux-ci sont endommagés, les
débrancher de la prise de courant et contacter un centre de service
agréé.
Circuit de protection
Les enceintes sont munies de circuits les protégeant contre les
dommages que peuvent causer un signal d’entrée trop élevé ou
anormal ; lorsqu’un signal trop intense est détecté, l’acheminement
du signal est automatiquement coupé.
Dans le cas où le son est interrompu…
1.Baisser le volume sur le récepteur ou l’amplificateur.
2.Vérifier la source sonore et les raccordements. Si aucun problème
n’est détecté, le circuit de protection sera réarmé dans quelques
minutes.
Suite au réarmement du circuit de protection…
Veiller à ne pas trop monter le volume sur le récepteur.
Signal d’entrée excessif
S’assurer de réduire le volume sur le récepteur (ou amplificateur)
lorsque l’intensité du signal d’entrée excède la puissance admis-
sible des enceintes pour protéger les circuits et prévenir d’autres
problèmes de fonctionnement.
Autres remarques
Ne pas retirer les treillis des enceintes.
Éloigner les enceintes de tout objet magnétisé
Les cartes magnétiques, cartes de guichet automatique, etc.,
pourraient être endommagées si elles sont placées à proximité de
l’aimant d’un haut-parleur. Les horloges peuvent aussi être affectées.
Éviter de placer les enceintes :
Dans un endroit exposé aux rayons solaires directs ;
Près d’une source de chaleur ;
Dans un endroit humide.
Entretien
Pour nettoyer l’appareil, utiliser un chiffon doux et sec.
Si les surfaces sont très sales, utiliser un chiffon doux trempé dans
une solution d’eau et de savon ou de détergent doux.
Ne jamais utiliser d’alcool, diluant pour peinture ni de benzine pour
nettoyer l’appareil.
Avant d’utiliser un chiffon traité chimiquement, lire attentivement
les directives sur l’emballage du chiffon.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics SBCSS135 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics SBCSS135 in the language / languages: English as an attachment in your email.

The manual is 1,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info