635679

Swan SW351-KCH Keypad PIR Alarm Manual

7
Zoom out
Zoom in
Previous page
1/8
Next page
7
Maintenance and Technical Specifications
Passcode
Your passcode must be four digits long, and should be something that you will
remember. Try to avoid obvious combinations (such as 1234 or similar).
To set your passcode:
If you’ve already mounted the alarm unit, remove it from its mounting •
bracket.
Open the battery compartment on the rear of the alarm.•
Locate the button labeled LEARN.•
Press this button.•
Then, enter your four digit passcode. When entering the passcode, press •
buttons slowly and deliberately, waiting for the alarm unit to beep quickly to
confirm each button press.
A louder, longer beep will confirm that a new passcode has been set.•
Low Battery Indicator
When the batteries in the alarm unit are running out, the LED on the front of the
alarm unit will flash slowly (more slowly than during the arming delay). If the LED
starts flashing in this way, change the batteries immediately.
Replacing Batteries
The batteries in the alarm system should be replaced every six months. If you’re
using the sensor in chime mode and get a lot of visitors, you may need to change
them more often.
Remove the sensor from its mounting bracket.•
On the rear side of the sensor, locate the battery compartment. •
Technical Specifications: PIR Motion Sensor
Power Requirements 3 x Alkaline AAA Batteries (4.5V DC)
Modes 2 (Alarm and Chime)
PIR Detection Range > 7m (Typical – varies by environment)
Alarm Mode
Passcode Protected Yes (4-digit numerical code)
Passcode Learning Duration 15s
Siren Volume > 110dB
Siren Duration 30s
Entry Delay 30s
Exit Delay 45s
Re-Trigger Delay 3s
Chime Mode
Chime Volume > 90dB
Chime Duration Approx. 2s
Re-Trigger Delay 3s
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Swan SW351-KCH Keypad PIR Alarm at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Swan SW351-KCH Keypad PIR Alarm in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info